Qtech QSW-8200-28T-AC — настройка VLAN: Руководство по конфигурации и командам [8/41]

Превью страниц Страница 8 / 41

User Manual

Chapter 1. VLAN Configuration 8

www.qtech.ru

1.1.10 garp timer leaveAll

 Command: garp timer leaveall <5000-60000>

 Function: Set the value of garp leaveAll timer, note that the value of leaveAll timer

must be larger than leave timer.

 Parameters: <5000-60000>, the value of timer in millisecond

 Command Mode: Global mode

 Default: 10000 ms.

 Usage Guide: Check whether the value satisfy the range. If so, modify the value of garp

leaveAll timer to the specified value, otherwise return a configuration error.

 Example: Set the value of garp leaveAll as 20000ms.

 Switch(config)#garp timer leaveall 20000

1.1.11 gvrp (Global)

 Command: gvrp

 no gvrp

 Function: Enable/disable GVRP funciton globally.

 Parameters: None.

 Command Mode: Global mode

 Default: Disabled.

 Usage Guide: Enable GVRP function globally and only in this way GVRP module can

work normally.

 Example: Enable GVRP function globally.

 Switch(config)#gvrp

1.1.12 gvrp (Port)

 Command: gvrp

 no gvrp

 Function: Enable/disable GVRP function on port. Notice: although GVRP can be enabled

on port when GVRP is not enabled globally, it will not take effect until global GVRP is

enabled.

 Parameters: None

 Command Mode: Port mode

 Default: Disabled

 Usage Guide: GVRP function can only be enabled on trunk and hybrid ports, and

enabling GVRP will return an error on access port. After GVRP enabled on port, this port

will be added to GVRP (i.e. adding corresponding state machine to GVRP of the port).

 Example: Enable GVRP of port.

 Switch(config-if-ethernet1/0/1)#gvrp

1.1.13 no garp timer

 Command: no garp timer (join | leave | leaveall)