Qtech QSW-8200-28T-POEAC- DC Команды для протокола многоадресной рассылки онлайн [35/39] 481628

User Manual

Chapter 2. IPv6 Multicast Protocol 35

www.qtech.ru

 Function: Configure static-group on specified port of the VLAN. The no form of the

command cancels this configuration.

 Parameter: vlan-id: ranging between <1-4094>

 X:X::X:X:The address of group or source.

 ethernet: Name of Ethernet port

 port-channel: Port aggregation

 ifname: Name of interface

 Command Mode: Global mode

 Default: No configuration by default.

 Usage Guide: When a group is a static while also a dynamic group, it should be taken as

a static group. Deleting static group can only be realized by the no form of the

command.

 Example:

 Switch(config)#ip igmp snooping vlan 1 static-group ff1e::15 source 2000::1 interface

ethernet 1/0/1

2.2.16 ipv6 mld snooping vlan suppression-query-time

 Command: ipv6 mld snooping vlan <vlan-id> suppression-query-time <value>

 no ipv6 mld snooping vlan <vlan-id> suppression-query-time

 Function: Configure the suppression query time; the “no” form of this command

restores the default value.

 Parameter: vlan-id: VLAN ID, valid range: <1-4094>

 value: valid range: <1-65535>secs.

 Command Mode: Global Mode

 Default: 255s

 Usage Guide: This command can only be configured on L2 general querier. The

Suppression-query-time represents the period the suppression state maintains when

general querier receives queries from layer 3 MLD within the segment. To use this

command, the query-intervals in different switches within the same segment must be

in accordance. It is recommended to use the default value.

 Example:

 Switch(config)#ipv6 mld snooping vlan 2 suppression-query-time 270

2.2.17 show ipv6 mld snooping

 Command: show ipv6 mld snooping [vlan <vlan-id>]

 Parameter: <vlan-id> is the number of VLAN specified to display the MLD Snooping

messages

 Command Mode: Admin Mode

 Usage Guide: If no VLAN number is specified, it will show whether the global MLD

snooping is enabled and layer 3 multicast protocol is running, as well as on which VLAN

the MLD Snooping is enabled and configured l2-general-querier. If a VLAN number is

specified, the detailed MLD Snooping messages of this VLAN will be displayed.