Qtech QSW-8200-28F-AC [11/74] Match metric

User Manual

Chapter 1. Commands for Routing Policy 11

www.qtech.ru

 Parameters: next-hop is the next station for routing. ipv6-address is the ipv6 address

for the ip address of the interface on the next station.

 Command Mode: route map mode

 Usage Guide: If this command is configured, packets will be delivered according to the

next hop information in the routing table. If matched, the permit or deny operation in

the route map will be executed.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)# match ipv6 next-hop 2000::1

1.10 match metric

 Command: match metric <metric-val >

 no match metric [<metric-val >]

 Function: Match the metric value in the routing message. The “no match metric

[<metric-val >]” deletes the configuration.

 Parameter: <metric-val > is the metric value, ranging between 0～4294967295.

 Command Mode: route-map mode

 Usage Guide: This command matches according to metric value in the route. If the

matching succeeded, then the “permit” or “deny” action in the route-map is

performed.

 Example:

 Switch#config terminal

 Switch(config)#route-map r1 permit 5

 Switch(config-route-map)#match metric 60

1.11 match origin

 Command: match origin <egp | igp | incomplete >

 no match origin <egp | igp | incomplete >

 Function: Configure to matching with the origin of the BGP routing message. The “no

match origin <egp | igp | incomplete >” deletes the configuration.

 Parameter: egp means the route is learnt from the external gateway protocols, igp

means the route is learnt from the internal gateway protocols, incomplete means the

route origin is uncertain.

 Command Mode: route-map mode

 Usage Guide: This command matches according to origin message in the BGP route. If

the matching succeeded, then the “permit” or “deny” action in the route-map is

performed.

 Example:

 Switch#config terminal