Home
Главная
Kohler
Двигатель
Command PRO EFI propane PCV860
Руководство пользователя Страница: 8

Kohler Command PRO EFI propane PCV860 [8/10] Warning

Kohler Command PRO EFI propane PCV860 [8/10] Warning

8 19 590 05 Rev. --KohlerEngines.com

Air Cooling

WARNING

Hot Parts can cause severe

burns.

Do not touch engine while

operating or just after stopping.

Never operate engine with heat shields or

guards removed.

Proper cooling is essential. To prevent over

heating, clean screens, cooling ﬁ ns, and other

external surfaces of engine. Avoid spraying

water at wiring harness or any electrical

components. See Maintenance Schedule.

Repairs/Service Parts

We recommend that you use a Kohler

authorized dealer for all maintenance, service,

and engine parts. To ﬁ nd a Kohler authorized

dealer visit KohlerEngines.com or call 1-800-

544-2444 (U.S. and Canada).

Storage

If engine will be out of service for 2 months or

more follow procedure below.

1. Change oil while engine is still warm from

operation. Remove spark plug(s) and pour

about 1 oz. of engine oil into cylinder(s).

Replace spark plug(s) and crank engine

slowly to distribute oil.

2. Disconnect negative (-) battery cable.

3. Separate propane tank from unit and store

separately in an area designated for safe

propane tank storage.

4. Store engine in a clean, dry place.

Air Cleaner

NOTE: Operating engine with loose or

damaged air cleaner components

could cause premature wear and

failure. Replace all bent or damaged

components.

NOTE: Paper element cannot be blown out

with compressed air.

1. Unhook retaining clips and remove end

cap(s).

2. Check and clean inlet screen (if equipped).

3. Pull air cleaner element out of housing and

replace. Check condition of inner element (if

equipped); replace when dirty.

4. Check all parts for wear, cracks, or damage,

and that ejector area is clean.

5. Install new element(s).

6. Reinstall end cap(s) with dust ejector valve/

screen down; secure with retaining clips.

Breather Tube

Ensure both ends of breather tube are properly

connected.

Oil Cooler (if equipped)

1. Clean ﬁ ns with a brush or compressed air.

2. Remove two screws securing oil cooler, and

tilt to clean back side.

3. Reinstall oil cooler.

Содержание

Похожие устройства