Dexter Power PDH26G1 [35/56] Maintenance

1. If your power tool does not start, check the plug on the power supply rst.

2. If your hammer becomes too hot in use, set the hammer switch to the drill mode and allow your drill

to operate at maximum speed without load for 2 minutes.

3. If your hammer work e ciency is too low, please add su cient grease in the grease box.

4. If your hammer use in low e ciency, please check whether the tool is blunt.

5. If a fault can not be rectied, return the tool to an authorized dealer for repair.

Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.

There are no user serviceable parts in your power tool. Never use water or chemical cleaners to clean

your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry place. Keep the

motor ventilation slots clean. Keep all working controls free of dust. Occasionally you may see sparks

through the ventilation slots. This is normal and will not damage your power tool.

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly

qualied persons in order to avoid a hazard.

If the carbon brushes need to be replaced, have this done by a qualied repair person (always replace

the two brushes at the same time).

5. TROUBLESHOOTING

4. MAINTENANCE

6. ENVIRONMENTAL PROTECTION

This label indicates that this product should not be disposed with other

household wastes throughout the EU. To prevent possible harm to the

environment or human health from uncontrolled waste disposal, recycle it

responsibly to promote the sustainable reuse of material resources. To return your

used device, please use the return and collection systems or contact the retailer

where the product was purchased. They can take this product for environmentally safe

recycling.