Metabo TEPB 19-180 RT CED (600433500) Инструкция по эксплуатации онлайн [14/92] 503469
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Metabo TEPB 19-180 RT CED (600433500) Инструкция по эксплуатации онлайн [14/92] 503469

Metabo TEPB 19-180 RT CED (600433500) Инструкция по эксплуатации онлайн [14/92] 503469
ENGLISHen
14
dust mask. Ensure appropriate suction is available
when blowing out vents.
The machine does not start.The
electronic signal indicator (6) flashes.
Restart protection is active. If the mains plug is
inserted with the machine switched on or if the
power supply is restored following an interruption,
the machine does not start up. Switch the machine
off and back on again.
Use only genuine Metabo accessories.
Use only accessories that fulfil the requirements
and specifications listed in these operating
instructions.
The maximum permitted thickness of the
diamond cutting disc is 3 mm (1/8"). Do not
use any segmented diamond cutting discs with
segment slits >10 mm. If using segmented diamond
cutting discs, only a negative segment cutting angle
is permitted.
For a complete range of accessories, see
www.metabo.com or the catalogue.
Repairs to electrical tools must only be carried
out by qualified electricians!
A defective mains cable must be replaced only with
a special, original mains cable from Metabo
available from the Metabo service.
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: never dispose of
power tools in your household waste!
According to European Directive 2012/19/EU
on Waste from Electric and Electronic Equipment
and implementation in national law, used power
tools must be collected separately and recycled in
an environmentally-friendly manner.
Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
Ø = max. permitted diameter of the diamond
cutting discs
d
max
= max. permitted thickness of the diamond
cutting discs
M=Spindle thread
l = Length of the sanding spindle
T
max
= maximum cutting depth
n = No-load speed (maximum speed)
P
1
=Rated input power
P
2
= Power output
m = Weight without mains cable
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~ AC power
The technical specifications quoted are subject to
tolerances (in compliance with relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on operating conditions, the
condition of the power tool or the accessories used.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Total vibration value
(vector sum of three directions)
determined in accordance with EN 60745:
a
h
= vibration emission value
K
h
= uncertainty (vibration)
Typical A-weighted sound levels
:
L
pa
=Sound-pressure level
L
WA
= Acoustic power level
K
pA
, K
WA
= Uncertainty
Wear ear protectors!
11. Troubleshooting
12. Accessories
13. Repairs
14. Environmental Protection
15. Technical Specifications

Похожие устройства

Скачать