Greenworks G24ROS (3100107) [3/14] English original instructions

EN

DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET

English (Original Instructions)

3

Replacing the Sanding Sheet (see gure B-C)

To remove the sanding sheet 10, lift it from the side and

pull it off of the sanding plate 6.

When attaching a new sanding sheet, remove any dust or

debris from the sanding plate 6, e. g., with a brush.

punched holes in the sanding sheet match with the holes

in the sanding plate.

The dust box (alignment aid) 11 can be used for alignment

of the sanding sheet 10 on the sanding plate 6. Place

the sanding sheet with the Velcro facing upward on the

alignment aid. Press the cams of the alignment aid into

two holes of the sanding plate and roll off the sanding

sheet from the alignment aid. Press the sanding sheet

rmly against the sanding plate.

– Sanding plate, soft (grey, accessory): Suitable for

surfaces.

Replacing the Sanding Plate (see gures D–E)

Note: Replace a damaged sanding plate 6 immediately.

sanding plate 6.

Clean the upper side of the new sanding plate 6. Apply a

thin coat of synthetic grease to the outer ring hatched grey

Dust/Chip Extraction

■ Dust from materials such as lead-containing coatings,

Certain dust, such as oak or beech dust, is considered

carcinogenic, especially in connection with wood-

treatment additives (chromate, wood preservative).

Materials containing asbestos may only be worked by

Observe the relevant regulations in your country for

the materials to be worked.

■ Prevent dust accumulation at the workplace. Dust can

Integrated Dust Extraction with Dust Box(see

gures F-G)

To empty the dust box assembly 5, pull dust box 11 off

the power tool by squeezing both sides of dust box 11.

Empty the dust box 11and clean the dust box 11 with a

Selecting the Sanding Sheet

Select a sanding sheet with the appropriate grain as required for the desired surface removal rate. Greenworks sanding

sheets are suitable for paint, wood and metal.

− Light sanding down

− Light sanding of surfaces for

continued processing

− Face sanding and planing of irregularities

− Removing score marks from coarse-

sanding

medium 80

− Evening out/touching up before applying

paint/varnish

ne 120

− Intermediate varnish sanding

− Light sanding of coating defects

− Removal of bres from surfaces

− Fine sanding before staining or glazing

very ne 180

− Light sanding of primer prior to coating extra ne 240