Black & Decker CS1550 [9/32] Adjusting the bevel angle fig e
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Black & Decker CS1550 [9/32] Adjusting the bevel angle fig e

Black & Decker CS1550-QS [9/32] Adjusting the bevel angle fig e
9
ENGLISH
(Original instructions)
• Use a square to check that the angle
between the saw blade and the shoe is
90°. If the angle does not measure 90°
adjust as follows:
• Loosen the locking knob (19) to unlock
the saw shoe.
• Loosen the locknut (20) on the adjusting
screw (21).
• Screw the adjusting screw in or out to
achieve a 90° angle.
• Retighten the locknut.
• Tighten the locking knob to lock the saw
shoe in place.
Adjusting the depth of cut (fig. D)
The depth of cut should be set according to
the thickness of the workpiece. It should
exceed the thickness by approx. 2 mm.
• Loosen the knob (22) to unlock the saw
shoe.
• Move the saw shoe (6) into the desired
position.
The corresponding depth of cut can be read
from the scale (23).
• Tighten the knob to lock the saw shoe in
place.
Adjusting the bevel angle (fig. E)
This tool can be set to bevel angles between
0° and 45°.
• Loosen the locking knob (19) to unlock
the saw shoe.
• Move the saw shoe (8) into the desired
position. The corresponding bevel angle
can be read from the scale (24).
• Tighten the locking knob to lock the saw
shoe in place.
Switching on and o
• To switch the tool on, move the lock-off
button (2) into the unlock position and
squeeze the on/off switch (1).
• To switch the tool off, release the on/off
switch.
Sawing
Always hold the tool with both hands.
• Let the blade run freely for a few seconds
before starting the cut.
• Apply only a gentle pressure to the tool
while performing the cut.
• Work with the shoe pressed against the
workpiece.
Hints for optimum use
• As some splintering along the line of cut
on the top side of the workpiece cannot
be avoided, cut on the side where
splintering is acceptable.
• Where splintering is to be minimised, e.g.
when cutting laminates, clamp a piece of
plywood onto the top of the workpiece.
Using the sight guide (fig. F)
The tool is equipped with a sight guide for
straight cutting.
• Align the left edge of the guides (26)
with the cutting line (25).
• Keep the sight guide aligned with the
cutting line while sawing.
• Work with the shoe pressed against the
workpiece.
Dust extraction (fig. G)
An adaptor is required to connect a vacuum
cleaner or dust extractor to the tool.
• Insert the dust extraction adaptor (27)
into the saw dust outlet (10).
• Connect the vacuum cleaner hose (28) to
the adaptor.
Maintenance
Your BLACK+DECKER corded/cordless
appliance/tool has been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance on corded/cordless power
tools:

Содержание

Похожие устройства

Скачать