Home
Главная
Daikin
Чиллер
EWAD960C-PR
Характеристики Страница: 91

Daikin EWAD960C-PR [91/96] Installation notes

Daikin EWADC14C-SL [91/96] Installation notes

Warning

Installation and maintenance of the unit must to be performed only by qualified personnel who have knowledge with

local

codes and regulations, and experience with this type of equipment. Must be avoided the unit installation in places that could

considered dangerous for all the maintenance operations.

Handling

Care should be taken to avoid rough handling or shock

due to dropping the unit. Do not push or pull the unit from

anything other than the base frame. Never allow the unit to fall during unloading or moving as this may result in serious dam

age. To

lift the unit, rings are provided in the base frame of the unit

. Spreader bar and cables should be arranged to prevent damage to the

condenser coil or unit cabinet.

Location

The units are produced for outside installation on roofs, floors or below ground level on condition that the area is free fro

obstacles for the

passage of the condenser air. The unit should be positioned on solid foundations and perfectly level; in the case of

installation on roofs or floors, it may be advisable to arrange the use of suitable weight distribution beams. When the units are installed

on the ground, a concrete base at least 250 mm wider and longer than the unit’s footprint should be laid. Furthermore, this b

ase should

withstand the unit weight mentioned in the technical data table.

Space requirements

The units are air-cooled, then it i

s important to respect the minimum distances which guarantee the best

ventilation of the condenser coils. Limitations of space reducing the air flow could cause significant reductions in cooling

capacity and an

increase in electricity consumption.

To deter

minate unit placement, careful consideration must be given to assure a sufficient air flow across the condenser heat transfer

surface. Two conditions must be avoided to achieve the best performance: warm air recirculation and coil starvation.

Both these conditions cause an increase of condensing pressures that results in reductions in unit efficiency and capacity.

Moreover the unique microprocessor has the ability to calculate the operating environment of the air cooled chiller and the c

apacity to

optimize its performance staying on-line during abnormal conditions.

Each side of the unit must be accessible after installation for periodic service. Fig.1 shows you minimum recommended clearan

requirements.

Vertical condenser air discharge must be unobstructed because the unit would have its capacity and efficiency significantly reduced.

If the units are positioned in places surrounded by walls or obstacles of the same height as the units, the units should be a

t least 2500

mm from obstacles (Fig.2). In the eve

nt the obstacles are higher than the units, the units should be at least 3000 mm from the

obstacle (Fig.3). Units installed closer than the minimum recommended distance to a wall or other vertical riser may experien

ce a

combination of coil starvation and w

arm air recirculation, thus causing reduction in unit capacity and efficiency reductions. The

microprocessor control is proactive in response “of design condition”. In the case of single or compounded influences restric

ting airflow

to the unit, the microprocessor will act to keep the compressor(s) running (at reduced capacity) rather than allowing a shut-

off on high

discharge pressure.

When two or more units are positioned side by side it is recommended that the condenser coils are at least 3600 mm distance

from one

another (Fig.4); strong wind could be the cause of air warm recirculation.

For other installation solutions, consult our technicians.

The above recommended information are representative of general installation. A specific evaluation should be d

one by contractor

depending on the case.

INSTALLATION NOTES

Daikin EWAD960C-PR [91/96] Installation notes

Содержание

Похожие устройства