Ariston AD 1000 [25/32] Before calling read the following
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Ariston AD 1000 [25/32] Before calling read the following

Ariston AD 1000 [25/32] Before calling read the following
- Instructions for installation and use
Before calling, read the following
Troubleshooting
Your washing machine could fail to work. In most cases, the problems
arising can be easily solved without having to call for a technician. Before
calling for assistance, always check these points.
The washing machine
fails to start.
Is the plug correctly
inserted into the socket? It
could have been moved whilst
cleaning.
Is there electricity in the
house?
A circuit breaker could have
gone off, perhaps because too
many appliances are on at the
same time. Or perhaps because
of a general power failure in
your entire area.
Is the washing machine door
closed properly?
For safety reasons, the
washing machine cannot work
if the door is open or not shut
properly.
Is the On/Off button
pressed?
If it is, then a programmed
start has been set.
Has the Start/Reset button
been pressed?
If it is, then a programmed
start has been set.
Is the water tap open? For
safety reasons, if the washing
machine does not load water,
it cannot start a wash cycle.
RIGHT
WRONG
Close the tap
after every wash
cycle.
Limit the use of
the washing
machines
hydraulic system
and eliminate
leakage risks
when no-one is at
home.
Always leave the
appliance door
ajar to avoid bad
odours.
Clean the
appliances
exteriors
delicately.
To clean the
exteriors and the
rubber parts of
the appliance,
always use a rag
dipped in
lukewarm water
and soap.
Leave the washing
machine plugged in
while cleaning.
Even during mainte-
nance, the appliance
should always be
unplugged.
Use solvents and
aggressive abrasives.
Never use solvents or
abrasives to clean the
external and rubber
parts of the washing
machine.
Neglect the detergent
dispenser.
It is removable and
can easily be cleaned
by leaving it under
running water.
Go on holiday without
thinking about her.
Before leaving, always
make sure that the
washing machine is
unplugged and that
the water tap is
closed.
The washing machine
fails to load water.
Is the tap correctly
attached to the pipe ?
Is there a water shortage ?
There could be work in
progress in your building or
street.
Is there enough pressure?
The autoclave may be
malfunctioning.
Is the tap filter clean? If the
water is very calcareous, or if
work has recently been carried
out on the water piping, the tap
filter could be clogged with
particles and debris.
Is the rubber hose bent? The
tract of the rubber hose
bringing water to the washing
machine must be as straight as
possible. Make sure it is not
squashed or bent.
The washing machine
continuously loads
and unloads water.
Is the drain hose
positioned too low? It must
be installed at a height ranging
from 60 to 100 cm.
Is the hoses mouth
immersed in water?
Does the wall drainage
system have a breather
pipe? If the problem persists
even after these checks, close
the water tap, switch the
appliance off and call for
assistance.
If you live on an upper floor of
your building, there may be a
problem with your drain trap.
To solve this problem, a special
valve must be installed.
22
Simple: with the new Ariston technology, you need less than
half of it, to get good results on twice as much!
This is why you cannot see the water through the door:
because there is little, very little of it, to respect the
environment yet without renouncing maximum cleanliness.
And, on top of that, you are also saving electricity.
But where did all the water go?

Содержание

Похожие устройства

MARGHERITA DIALOGIC Troubleshooting Before calling read the following Your washing machine could fail to work In most cases the problems arising can be easily solved without having to call for a technician Before calling for assistance always check these points The washing machine fails to start Is the plug correctly inserted into the socket It could have been moved whilst cleaning Is there electricity in the house A circuit breaker could have gone off perhaps because too many appliances are on at the sametime Or peihaps because of a general power failure in your entire area Is the washing machine door closed properly For safety reasons washing machine cannot work if the door is open or not shut properly Is the pressed On Off button If it is then a programmed start has been set But where did all the water go Sinrole with the new Ariston technology youneed less than half of it to get good results on twice as much This is why you cannot see the w ater through the door because there is little very little of it to respect the environment yet without renouncing maximum cleanliness And on top of that you are also saving electricity Has the Start Reset button been pressed If it is then a programmed start has been set Is the water tap open For safety reasons if the washing machine does not load water it cannot start a wash cycle the The washing machine fails to load water RIGHT WRONG Is the tap correctly attached to the pipe The washing machine continuously loads and unloads water Is there a w ater shortage Close the tap after every wash cycle Limit the use of the washing machine s hydraulic system and eliminate leakage risks when no one is at home Always leave the appliance door ajar to avoid bad odours Clean the appliance s exteriors delicately To clean the exteriors and the rubber parts of the appliance always use a rag dipped in lukewarm water and soap Leave the washing machine plugged in while cleaning Even during mainte nance the appliance should always be unplugged Use solvents and aggressive abrasives Never use solvents or abrasives to clean the external and rubber parts of the washing machine Neglect the detergent dispenser It is removable and can easily be cleaned by leaving it under running water Go on holiday without thinking about her Before leaving always make sure that the washing machine is unplugged and that the water tap is closed There could be work in progress in your building or street be installed at a height ranging from 60 to 100 cm Is the hose s immersed in w ater Does the wall drainage system have a breather pipe If the problem persists Is there enough pressure The autoclave malfunctioning may be Is the tap filter clean If the water is very calcareous or if w ork has recently been carried out on the water piping the tap filter could be clogged with particles and debris Is the rubber hose bent The tract of the rubber hose bringing water to the washing machine must be as straight as possible Make sure it is not squashed or bent MARGHERITA DIALOGIC Is the drain hose positioned too low It must mouth even after these checks close the water tap switch the appliance off and call for assistance If you live on an upper floor of your building there may be a problem with your drain trap To solve this problem aspecial valve must be installed Instructions forinsta lation and use 22

Скачать