Bowers & Wilkins MT-50 [6/6] Adjusting the angle of the speaker

ENGLISH

6 Adjusting the angle of the speaker

There are two screws next to the ball socket joint at

the back of the speaker that tighten the joint to hold

the speaker in place. It is only necessary to loosen

one of these to free the joint. Indeed, in portrait

orientation, only one screw will be accessible

(Figure 17).

Use the supplied Torx key to loosen and tighten the

screws.

7 Rotating the badge

If using the speaker in landscape orientation, you

will need to rotate the logo badge through 90º. The

badge is spring loaded. Use the plastic lm tted to

the rear of the badge to pull it out and rotate it. After

doing so, remove the lm (Figure 18).

8 Environmental Information

This product complies with international directives,

including but not limited to:

i. the Restriction of Hazardous Substances (RoHS)

in electrical and electronic equipment,

II. the Registration, Evaluation, Authorisation and

restriction of CHemicals (REACH)

iii. the disposal of Waste Electrical and Electronic

Equipment (WEEE).

Consult your local waste disposal authority for

guidance on how properly to recycle or dispose

of this product.

Figure 17

Figure 18