AXIOMET AX-3010H [2/5] Failure to observe this warning may cause injury to persons and

AXIOMET AX-3010H [2/5] Failure to observe this warning may cause injury to persons and
Keep this manual in a safe place for quick reference at all times.
This manual contains important safety and operation instructions for correct use of
the power supply. Read through the manual and pay special attention to the
markings and labels of this unit and equipment to be connected.
Pay special attention to these two types of notices used in this manual.
WARNING:
Failure to observe this warning may cause injury to persons and
damage to power supply or connected equipment.
CAUTION:
Failure to observe this warning may result in damage to equipment
and Improper functioning of the power supply.
WARNING:
1. Do not use this power supply near water.
2. Do not operate or touch this power supply with wet hands.
3. Do not open the casing of the power supply when it is connected to ac mains.
4. Refer all servicing to qualified service personnel only.
5. The power supply is designed for in-door use.
6. This power supply is made to charge only properly sized lead acid batteries.
7. Don't recharging non-rechargeable batteries.
8. Charging other types of battery or under-sized lead acid batteries may cause fire
or explosion.
9. Do not use the charger if it has been dropped or damaged.
10. Do not remove casing of the charger, there is no user-serviceable parts inside.
11. Do not charge the battery on boats. Remove the battery and charge on shore.
12. Never attempt to charge a frozen battery
13. Never attempt to charge a damaged battery.
14. Wear protective goggles and turn your face away when connecting
disconnecting the battery.
15. Never place the charger on top of a battery.
16. Never smoke, use an open flame, or create sparks near battery or charger
during normal charging operation as batteries may give out explosive gas.
17. Do not charge batteries in an enclosure (box- in) due to possible explosion of
entrapped explosive gas.
18. Use of accessory not recommended may cause risk of fire, electric shock.
19. Disconnect the mains supply before connecting or disconnecting the links to
the battery.
20. If the charger does not work properly or if it has been damaged, unplug its AC
and DC connection.
21. During charging, the battery must be placed in a well ventilated area.
22. If longer output charging cord is required make sure the diameter is adequate
for the current in given cable length.
23. Charging will stop when cars ignition is turned off.
INTRODUCTION
Congratulations on purchasing our new Digital Multipurpose Switching Mode
Power Supply, This device USES a very wide range, in addition to the general use
of power, but also for the car lead-acid battery, for charging the mobile phone
through USB port. Please read this user manual before the operation.
Скачать