Liberton LED 3945 DW3D [64/92] Led 3945 dw3d smart

www.liberton.com.ua

– How to set up manually (Wired)

Use the Manual Network Setup when connecting your

TV to a network that requires a Static IP address.

1. Follow Steps 1 through 4 in the “How to set up

automatically” procedure.

2. Set Conf. to Static.

3. Press the ▲/▼ button to highlight IP, and then press

the ENTER button.

4. Press the ▲/▼ button to highlight the field you want

to change, and then use the number buttons to input

the IP address. When done, select the OK and press

ENTER save the setting.

5. Press ▲/▼ to highlight Netmask, Gateway and

DNS, and edit in the same way as IP address.

NOTE:

• IP, Netmask, Gateway and DNS address field

numbers must be between 0 and 255.

• If you manually set the IP address, you must not use the same IP address for any

other device. The IP address you use should be a private address.

Tips for Network Connection:

• Use a standard LAN cable with this TV. Cat5 or better with a RJ45 connector.

• If you have a Dynamic Network, you should use an ADSL modem or router that

supports Dynamic Host Configuration Protocol (DHCP). Modems and routers that

support DHCP automatically provide the IP address, netmask, gateway and DNS

values your TV needs to access the Internet.

• Some networks require a Static IP address. If your network requires a Static IP

address, you must enter the IP address, netmask, gateway and DNS values manually

when you set up the network connection. If you do not know the correct values to use,

please contact your network administrator or internet service provider.

• Many network connection problems during set up can often be fixed by re-setting the

router or modem. After connecting the player to the home network, quickly power off

and/or disconnect the power cable of the home network router or cable modem.

Then power on and/or connect the power cable again.

TELEVISION LIBERTON

LED 3945 DW3D (Smart)