Gazer CM6008-J150H [7/93] Installation tips

ENG

Installation Tips

• For Gazer multimedia system installation, one must check that all plugs and jacks are connected in accordance with the

connection diagram.

• Make sure that the yellow «BATT+» wire of the power cable is connected to the plus terminal of the car battery while the

red «ACC» wire is connected to the auxiliary equipment bus (+12V voltage is supplied when the ignition key is turned

to АСС position).

• Prior to installing the system, one must consider where to place the remote elements such as GPS antennas and USB

ports.

• Lay all cables under the trim.

• Connect the stock USB and AUX connectors to the multimedia system (depending on the car model).

• If model of your multimedia system has a built-in DVD drive, unscrew two safety screws located in the center of the top

panel prior to installing and the ﬁ rst start-up.

• Prior to using the device, insert a memory card in the «SD card» slot.

• To use all Gazer multimedia system functionalities, one must connect it to the Internet.

Caution! Incorrect power connection may cause the multimedia system to malfunction or fail.

Caution! Remove the memory card only when the device is switched off.