KRAFT Technology TCH-HV6910BLE [25/32] Adaptation to different types of gas

ВСТРАИВАЕМАЯ ГАЗОВАЯ ВАРОЧНАЯ ПАНЕЛЬ

GAS BUILT-IN HOB

ИНСТРУКЦИЯ ПО ЭКСПЛУАТАЦИИ • USER GUIDE

To perform these operations the qualified installer will follow the indications given in the

«Adaptation to the various types of gas» section. For safety operation, make sure that the

supply pressure respects the values given in the «Table of burner and injector characteristics».

If the appliance is supplied with liquid cylinder gas, make sure that the cylinder pressure

regulator conforms to the local regulations in force.

• The appliance must be connected to the

gas system by a rigid metal pipe (copper

or steel) or continuous wall stainless

steel flexible hose in such a way that the

appliance is not stressed in any way.

• The appliance gas inlet tube has an end

nut to which is connected the elbow union

(supplied, 1/2 thread male gas). It can be

turned depending on installation needs.

• The rigid or flexible metal supply pipe

(l max = 2 m) is connected to the part

opposite the elbow union. Remember to

put the gaskets supplied at the two ends

of the elbow union.

• When these parts are disassembled and

reassembled, always replace the gaskets

with new ones.

• Once the appliance is installed, check that the

gas pipe is not pinched or damaged by mobile

parts.

To adapt the appliance to a gas different from that for which it was set

up (see label on both the packaging and the bottom of the appliance)

proceed as follows:

• Remove the grids.

• Remove the covers and the spreaders.

• With a 7 mm socket spanner unscrew and remove the injectors.

• Replace the injectors with those supplied corresponding to the gas

available (see burner and injector characteristics table).

• Replace the various parts proceeding in reverse. Whenever the

gas pressure used is different (or variable) from that used, install a

pressure regulator which conforms to the local regulations in force

on the input pipe.

Whenever the gas pressure used is different (or variable) from

that used, install a pressure regulator which conforms to the local

regulations in force on the input pipe.

ADAPtAtIon to DIFFeRent tYPes oF GAs