MEAN WELL HBG-100-60A [2/9] Hbg 10

File Name:HBG-100-SPEC 2018-09-30

SPECIFICATION

HBG-100 series

MODEL

OUTPUT

VOLTAGE RANGE

Note.3

FREQUENCY RANGE

POWER FACTOR

EFFICIENCY (Typ.)

Note.5

AC CURRENT (Typ.)

INPUT

INRUSH CURRENT (Typ.)

LEAKAGE CURRENT

SAFETY STANDARDS

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVER CURRENT

OVER VOLTAGE

OVER TEMPERATURE

90 ~ 305VAC 127 ~ 431VDC

47 ~ 63Hz

COLD START 60A(twidth=550 s measured at 50% Ipeak) at 230VACμ;Per NEMA 410

<0.75mA / 277VAC

95 ~ 108%

Constant current limiting

20 ~ 95% RH non-condensing

-40 ~ +80 , 10 ~ 95% RH℃

±℃ ℃0.03%/ (0 ~ 50 )

10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes

985.6K hrs min. Telcordia SR-332 (Bellcore) ; Khrs min. MIL-HDBK-217F (25 )300 ℃

Shut down o/p voltage re-power on to recovery

ENVIRONMENT

SAFETY &

EMC

PROTECTION

Shut down o/p voltage re-power on to recovery

EMC IMMUNITY

EMC EMISSION Note.7

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃

Compliance to EN55015, EN61000-3-2 Class C ; EN61000-3-3()@load 60%≧ , GB17743 and GB17625.1, EAC TP TC 020

Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547,light industry level ( )surge immunity:Line-Earth:4KV,Line-Line:2KV , EAC TP TC 020

CURRENT ADJ. RANGE

TOTAL HARMONIC DISTORTION

MAX. No. of PSUs on 16A

CIRCUIT BREAKER

4 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC

(Please refer to "STATIC CHARACTERISTIC" section)

PF>0.96/115VAC, PF>0.96/230VAC, PF>0.94/277VAC full load@

(Please refer to " " )POWER FACTOR (PF) CHARACTERISTIC section

THD< 20%(@load 60%/115VC,230VAC; @load 75%/277VAC)≧≧

(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)

WORKING TEMP.

Tcase=-40 ~ +85 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)℃

MAX. CASE TEMP.

Tcase=+85℃

Adjustable for A/AB-Type (via built-in potentiometer)

90.5%

91%

91.5%

91%

28 ~ 35V

41 ~ 49V

65 ~ 75V

54 ~ 63V

CONSTANT CURRENT REGION

Note.2

RATED CURRENT

RATED POWER

SETUP TIME

Note.4

CURRENT TOLERANCE

CURRENT RIPPLE

HBG-100-24

HBG-100-36

HBG-100-60

HBG-100-48

25V

37V

62V

49V

14.4 ~ 24V

21.6 ~ 36V

36 ~ 60V

28.8 ~ 48V

96W

2.7A

97.2W

1.6A

96W

2.4 ~ 4A

1.62 ~ 2.7A

1.2 ~ 2A

1.0 ~ 1.6A

±5.0%

5.0% max. @rated current

2000ms / 115VAC 500ms / 230VAC

1.1A / 115VAC 0.5A / 230VAC 0.45A / 277VAC

UL8750(type”HL”),CSA C22.2 No.250.13-12, ENEC EN61347-1, GB19510.1,GB19510.14EN61347-2-13 independent, EN62384; ,

BIS IS15885(for 36A,48A,60A only), P approvedIP65 or I 67EAC TP TC 004,

1.18Kg; 12pcs/15.7Kg/1.43CUFT(Blank/A/B Type),1.89CUFT(E Type)

100W Constant Current Mode LED Driver

OPEN CIRCUIT VOLTAGE(max.)

ψ130mm *66.5mm (D * H)

1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25 of ambient temperature.℃

2. Please refer to "DRIVING METHODS OF LED MODULE".

De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details

4. Length of set up time is measured at cold first start. Turning ON/OFF the driver may lead to increase of the set up time.

5. The DA type power supply is less efficient than the typical efficiency in specification by 1%.

6. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected

by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

7. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch without permanently

connected to the mains.

8. This series meets the typical life expectancy of >50,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 75 or less.℃

9. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com

10. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃

11. For any application note and IP water proof function installation caution, please refer our user manual before using.

https://www.meanwell.com/Upload/PDF/LED_EN.pdf

DALI STANDARDS

Compliance to IEC62386-101, 102, 207 for DA-Type only

MEAN WELL HBG-100-60A [2/9] Hbg 10

Содержание

Похожие устройства