MEAN WELL HLG-100H-20AB [2/10] Hlg 100

SPECIFICATION

File Name:HLG-100H-SPEC 2018-09-30

100W Constant Voltage + Constant Current LED Driver

HLG-100H series

WITHSTAND VOLTAGE

ISOLATION RESISTANCE

I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:1.5KVAC

I/P-O/P, I/P-FG, O/P-FG:100M Ohms / 500VDC / 25 / 70% RH℃

MODEL

DC VOLTAGE

RATED CURRENT

RATED POWER

OUTPUT

VOLTAGE ADJ. RANGE

CURRENT ADJ. RANGE

LINE REGULATION

LOAD REGULATION

SETUP, RISE TIME

Note.6

HOLD UP TIME (Typ.)

VOLTAGE RANGE

Note.5

FREQUENCY RANGE

POWER FACTOR (Typ.)

EFFICIENCY (Typ.)

AC CURRENT (Typ.)

INPUT

INRUSH CURRENT (Typ.)

LEAKAGE CURRENT

SAFETY STANDARDS

Note.8

WORKING TEMP.

WORKING HUMIDITY

STORAGE TEMP., HUMIDITY

TEMP. COEFFICIENT

VIBRATION

MTBF

DIMENSIONOTHERS

NOTE

PACKING

OVER CURRENT

OVER VOLTAGE

OVER TEMPERATURE

47 ~ 63Hz

1.2A / 115VAC 0.55A / 230VAC 0.5A / 277VAC

<0.75mA / 277VAC

95 ~ 106%

Compliance to EN55015, EN55032 Class B, EN61000-3-2 Class C ( ) ; EN61000-3-3≧60% ,GB17743 and GB17625.1, EAC TP TC 020@ load

20 ~ 95% RH non-condensing

-40 ~ +80 , 10 ~ 95% RH℃

±℃ ℃0.03%/ (0 ~ 60 )

10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes

192.2K hrs min. MIL-HDBK-217F (25 )℃

220*68*38.8mm (L*W*H)

RIPPLE & NOISE (max.) Note.2

VOLTAGE TOLERANCE

Note.3

ENVIRONMENT

SAFETY &

EMC

PROTECTION

Shut down o/p voltage, recovers automatically after temperature goes down

SHORT CIRCUIT

23 ~ 27V

28 ~ 34V

34 ~ 38V

41 ~ 46V

54 ~ 63V

47 ~ 53V 59 ~ 65V

93%

93%93% 93%

±1.0% ±1.0% ±1.0%

±1.0%

±0.5% ±0.5% ±0.5%

±0.5%

±0.5% ±0.5% ±0.5%

±0.5%

±1.0%

±0.5%

±1.0%

±0.5%

20V

HLG-100H-20 HLG-100H-30 HLG-100H-42 HLG-100H-54HLG-100H-24 HLG-100H-36 HLG-100H-48

24V

36V

48V

150mVp-p

17 ~ 22V

150mVp-p

22 ~ 27V

200mVp-p

27 ~ 33V

200mVp-p

33 ~ 40V

200mVp-p

43 ~ 53V

54V

200mVp-p

49 ~ 58V

42V

200mVp-p

38 ~ 46V

Constant current limiting, recovers automatically after fault condition is removed

Shut down o/p voltage with auto-recovery or re-power on to recovery

3 ~ 4.8A 2.5 ~ 4A 2 ~ 3.2A

1.65 ~ 2.65A

1.25 ~ 2A 1.1 ~ 1.77A

1.4 ~ 2.28A

4.8A 4A

3.2A

2.65A

96W 96W 96W

95.4W

96W

1.77A

95.58W

2.28A

95.76W

1.12Kg; 12pcs/14.4Kg/0.8CUFT

EMC IMMUNITY

EMC EMISSION

Note.8

UL8750 , CSA C22.2 No. 250.0-08; 61347-1, 61347-2-13 independent;(type”HL”) EN/AS/NZS EN/AS/NZS

GB19510.1,GB19510.14, ,(except for AB,D-type)IP65 or IP67, J61347-1, J61347-2-13, KC61347 1 KC61347 2 13-, --

EAC TP TC 004 approved ; design refer to UL60950-1, TUV EN60950-1

COLD START 60A(t =415 s measured at 50% I ) at 230VACwidth peak ; Per NEMA 410

TOTAL HARMONIC DISTORTION

CONSTANT CURRENT REGION

Note.4

10 ~ 20V 12 ~ 24V 15 ~ 30V

18 ~ 36V

24 ~ 48V 27 ~ 54V

21 ~ 42V

MAX. No. of PSUs on 16A

CIRCUIT BREAKER

4 units (circuit breaker of type B) / 8 units (circuit breaker of type C) at 230VAC

30V

1. All parameters NOT specially mentioned are measured at 230VAC input, rated current and 25 of ambient temperature.℃

2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.

3. Tolerance : includes set up tolerance, line regulation and load regulation.

4. Please refer to "DRIVING METHODS OF LED MODULE".

5. De rating may be needed under low input voltages. Please .- refer to STATIC CHARACTERISTIC sections for details

6. Length of set up time is measured at first cold start. Turning ON/OFF the driver may lead to increase of the set up time.

7. The driver is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the

complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.

8.To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch without permanently

connected to the mains.

9. This series meets the typical life expectancy of >62,000 hours of operation when Tcase, particularly tc point (or TMP, per DLC), is about 80 or less.℃

10. Please refer to the warranty statement on MEAN WELL's website at http://www.meanwell.com

11. The ambient temperature derating of 3.5 /1000m with fanless models and of 5 /1000m with fan models for operating altitude higher than 2000m(6500ft).℃℃

12. For any application note and IP water proof function installation caution, please refer our user manual before using.

https://www.meanwell.com/Upload/PDF/LED_EN.pdf

Adjustable for A/AB-Type only (via built-in potentiometer)

16ms / 115VAC, 230VAC

1200ms,50ms/115VAC 500ms,50ms/230VAC

90 ~ 305VAC 127 ~ 431VDC

(Please refer to "STATIC CHARACTERISTIC" section)

PF 0.98/115VAC, PF 0.95/230VAC, PF 0.93/277VAC @ full load≧≧≧

(Please refer to " " section)POWER FACTOR (PF) CHARACTERISTIC

THD< 20% (@ load 60% / 115VAC,230VAC; @ load 75% / 277VAC)≧≧

(Please refer to TOTAL HARMONIC DISTORTION (THD) section)""

MAX. CASE TEMP.

Tcase= +80℃

Tcase= -40 ~ +80℃

(Please refer to "OUTPUT LOAD vs TEMPERATURE" section)

Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, industry level ( )light surge immunity Line-Earth 4KV, Line-Line 2KV ,

EAC TP TC 020

MEAN WELL HLG-100H-20AB [2/10] Hlg 100

Содержание

Похожие устройства