MEAN WELL LPF-16D-20 [2/8] Lpf 16d

MEAN WELL LPF-16D-15 [2/8] Lpf 16d
LPF-16D series
SPECIFICATION
MODEL
OUTPUT
VOLTAGE RANGE Note.5
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
47 ~ 63Hz
<0.75mA / 240VAC
Compliance to
EN55015
,EN61000-3-2 Class C (@load55%) ; EN61000-3-3
20 ~ 95% RH non-condensing
-40 ~ +80, 10 ~ 95% RH
±0.03%/ (0 ~ 50)
10 ~ 500Hz, 2G 12min./1cycle, period for 72min. each along X, Y, Z axes
1249.2K hrs min. Telcordia SR-332 (Bellcore) ; 420.1Khrs min. MIL-HDBK-217F (25)
ENVIRONMENT
EMC EMISSION Note.8
SAFETY &
EMC
PROTECTION
I/P-O/P:3.75KVAC
I/P-O/P:100M Ohms / 500VDC / 25/ 70% RH
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
TOTAL HARMONIC DISTORTION
DC VOLTAGE
RATED CURRENT
RATED POWER Note.5
SETUP, RISE TIME Note.6
HOLD UP TIME (Typ.)
CONSTANT CURRENT REGION Note.2
OVER CURRENT
SAFETY STANDARDS Note.8
COLD START 45A(twidth=200 s measured at 50% Ipeak) at 230VACμ ; Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
14 units (circuit breaker of type B) / 24 units (circuit breaker of type C) at 230VAC
MAX. CASE TEMP.
Tcase=+70
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level (surge immunity Line-Line 2KV)
(Please refer to "STATIC CHARACTERISTIC" section)
90 ~ 305VAC 127 ~ 431VDC
1.AllparametersNOTspeciallymentionedaremeasuredat230VACinput,ratedcurrentand25ofambienttemperature.
2.Pleasereferto"DRIVINGMETHODSOFLEDMODULE".
3.Ripple&noisearemeasuredat20MHzofbandwidthbyusinga12"twistedpair-wireterminatedwitha0.1uf&47ufparallelcapacitor.
4.Tolerance:includessetuptolerance,lineregulationandloadregulation.
5.De-ratingmaybeneededunderlowinputvoltages.Pleasereferto“STATICCHARACTERISTIC”sectionsfordetails.
6.Lengthofsetuptimeismeasuredatfirstcoldstart.TurningON/OFFthedrivermayleadtoincreaseofthesetuptime.
7.Thedriverisconsideredasacomponentthatwillbeoperatedincombinationwithfinalequipment.SinceEMCperformancewillbeaffectedbythe
completeinstallation,thefinalequipmentmanufacturersmustre-qualifyEMCDirectiveonthecompleteinstallationagain.
8.ThemodelcertifiedforCCC(GB19510.14,GB19510.1,GB17743andGB17625.1)isanoptionalmodel.PleasecontactMEANWELLfordetails.
9. To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch
without permanently connected to the mains.
10.Thisseriesmeetsthetypicallifeexpectancyof>50,000hoursofoperationwhenTcase,particularlytcpoint(orTMP,perDLC),isabout70orless.
11.PleaserefertothewarrantystatementonMEANWELL'swebsiteathttp://www.meanwell.com
95 ~ 108%
Constant current limiting, recovers automatically after fault condition is removed
PF0.97/115VAC, PF0.95/230VAC, PF0.92/277VAC@full load
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 20%(@load60%/115VC,230VAC; @load75%/277VAC)
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
Tcase=-35 ~ +70 (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)
16ms/230VAC 16ms/115VAC
1500ms, 80ms / 115VAC 500ms, 80ms / 230VAC
Shut down and latch off o/p voltage, re-power on to recover
16W Constant Current Mode LED Driver
CURRENT TOLERANCE
CURRENT RIPPLE
±5.0%
5.0% max. @rated current
LPF-16D-12
LPF-16D-15
LPF-16D-20
LPF-16D-24
LPF-16D-30
LPF-16D-36
LPF-16D-42
LPF-16D-48
LPF-16D-54
12V 15V 20V 24V 30V
36V
48V 54V
42V
15 ~ 18V 17.5 ~ 21V
23 ~ 27V
28 ~ 35V
34 ~ 40V
41 ~ 49V 54 ~ 63V
46 ~ 54V 59 ~ 66V
SHORT CIRCUIT
Hiccup mode, recovers automatically after fault condition is removed.
Shut down o/p voltage, recovers automatically after temperature goes down
1.34A 1.07A 0.8A 0.67A
0.54A
0.45A
0.34A 0.3A
0.39A
16.08W
16.05W 16W 16.08W 16.2W
16.2W
16.32W 16.2W
16.38W
6.6 ~12V 8.25 ~ 15V 11 ~ 20V 13.2 ~ 24V 16.5 ~ 30V
19.8 ~ 36V
26.4 ~ 48V 29.7 ~ 54V
23.1 ~ 42V
83%
83%
84.5%
84.5%
84.5%
85%
85%85% 84.5%
0.4A / 115VAC 0.25A / 230VAC 0.2A/277VAC
UL8750, CSA C22.2 No. 250.0-08, ENEC EN61347-1, EN61347-2-13 independent,EN62384,J61347-1,
J61347-2-13 approved, IP67(optional); Design refer to UL60950-1, TUV EN60950-1
148*40*32mm (L*W*H)
0.21Kg;40pcs/9.4Kg/ 1.02CUFT
File Name:LPF-16D-SPEC 2017-04-13
Скачать