MEAN WELL LPF-90-36 [2/6] Lpf 90
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

MEAN WELL LPF-90-36 [2/6] Lpf 90

MEAN WELL LPF-90-42 [2/6] Lpf 90
LPF-90 series
SPECIFICATION
MODEL
OUTPUT
VOLTAGE RANGE Note.5
FREQUENCY RANGE
POWER FACTOR
EFFICIENCY (Typ.)
AC CURRENT
INPUT
INRUSH CURRENT(Typ.)
LEAKAGE CURRENT
EMC IMMUNITY
WORKING TEMP.
WORKING HUMIDITY
STORAGE TEMP., HUMIDITY
TEMP. COEFFICIENT
VIBRATION
MTBF
DIMENSIONOTHERS
NOTE
PACKING
OVER TEMPERATURE
OVER VOLTAGE
47 ~ 63Hz
<0.75mA / 240VAC
Compliance to
EN55015
,EN61000-3-2 Class C (@load≧60%) ; EN61000-3-3
20 ~ 95% RH non-condensing
-40 ~ +80℃, 10 ~ 95% RH
±0.03%/℃ (0 ~ 50℃)
10 ~ 500Hz, 5G 12min./1cycle, period for 72min. each along X, Y, Z axes
301.6Khrs min. MIL-HDBK-217F (25℃)
ENVIRONMENT
EMC EMISSION Note.8
SAFETY &
EMC
PROTECTION
I/P-O/P:3.75KVAC
I/P-O/P:100M Ohms / 500VDC / 25℃/ 70% RH
WITHSTAND VOLTAGE
ISOLATION RESISTANCE
TOTAL HARMONIC DISTORTION
DC VOLTAGE
RATED CURRENT
RATED POWER Note.5
LINE REGULATION
LOAD REGULATION
SETUP, RISE TIME Note.6
HOLD UP TIME (Typ.)
RIPPLE & NOISE (max.) Note.3
VOLTAGE TOLERANCE Note.4
CONSTANT CURRENT REGION Note.2
OVER CURRENT
SAFETY STANDARDS Note.8
COLD START 70A(twidth=435 s measured at 50% Ipeak) at 230VACμ ; Per NEMA 410
MAX. No. of PSUs on 16A
CIRCUIT BREAKER
4 units (circuit breaker of type B) / 6 units (circuit breaker of type C) at 230VAC
MAX. CASE TEMP.
Tcase=+70℃
Compliance to EN61000-4-2,3,4,5,6,8,11; EN61547, light industry level (surge immunity Line-Line 2KV)
(Please refer to "STATIC CHARACTERISTIC" section)
90 ~ 305VAC 127 ~ 431VDC
1.AllparametersNOTspeciallymentionedaremeasuredat230VACinput,ratedcurrentand25℃ofambienttemperature.
2.Pleasereferto"DRIVINGMETHODSOFLEDMODULE".
3.Ripple&noisearemeasuredat20MHzofbandwidthbyusinga12"twistedpair-wireterminatedwitha0.1uf&47ufparallelcapacitor.
4.Tolerance:includessetuptolerance,lineregulationandloadregulation.
5.De-ratingmaybeneededunderlowinputvoltages.Pleasereferto“STATICCHARACTERISTIC”sectionsfordetails.
6.Lengthofsetuptimeismeasuredatfirstcoldstart.TurningON/OFFthedrivermayleadtoincreaseofthesetuptime.
7.Thedriverisconsideredasacomponentthatwillbeoperatedincombinationwithfinalequipment.SinceEMCperformancewillbeaffectedbythe
completeinstallation,thefinalequipmentmanufacturersmustre-qualifyEMCDirectiveonthecompleteinstallationagain.
8.ThemodelcertifiedforCCC(GB19510.14,GB19510.1,GB17743andGB17625.1)isanoptionalmodel.PleasecontactMEANWELLfordetails.
9.To fulfill requirements of the latest ErP regulation for lighting fixtures, this LED driver can only be used behind a switch
withoutpermanentlyconnectedtothemains.
10.Thisseriesmeetsthetypicallifeexpectancyof>50,000hoursofoperationwhenTcase,particularlytcpoint(orTMP,perDLC),isabout70℃orless.
11.PleaserefertothewarrantystatementonMEANWELL'swebsiteathttp://www.meanwell.com
90W Constant Voltage + Constant Current LED Driver
95 ~ 108%
Constant current limiting, recovers automatically after fault condition is removed
PF≧0.97/115VAC, PF≧0.96/230VAC, PF≧0.92/277VAC@full load
(Please refer to "POWER FACTOR (PF) CHARACTERISTIC" section)
THD< 20%(@load≧60%/115VC,230VAC; @load≧75%/277VAC)
(Please refer to “TOTAL HARMONIC DISTORTION(THD)” section)
Tcase=-40 ~ +70℃ (Please refer to “ OUTPUT LOAD vs TEMPERATURE” section)
Shut down o/p voltage, re-power on to recover
±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0%
±0.5% ±0.5% ±0.5% ±0.5%
±0.5%
±0.5%
±1.5% ±1.0% ±0.5% ±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
±0.5%
15V
LPF-90-15 LPF-90-20 LPF-90-24 LPF-90-30 LPF-90-36 LPF-90-42 LPF-90-48 LPF-90-54
20V 24V 30V
36V
48V
5A 4.5A 3.75A
3A
2.5A
1.88A
75W 90W 90W 90W
90W
90.24W
150mVp-p 150mVp-p 150mVp-p 200mVp-p
200mVp-p
200mVp-p
54V
1.67A
90.18W
200mVp-p
42V
2.15A
90.3W
200mVp-p
9 ~ 15V 12 ~ 20V 14.4 ~ 24V 18 ~ 30V
21.6 ~ 36V
28.8 ~ 48V 32.4 ~ 54V
25.2 ~ 42V
16ms/230VAC 16ms/115VAC
1200ms, 200ms / 115VAC 500ms, 200ms / 230VAC
89%
90%
90.5%
91%
91%
91%91% 91%
0.95A / 115VAC 0.5A / 230VAC 0.4A / 277VAC
18 ~ 21V
23 ~ 27V
28 ~ 34V
34 ~ 38V
41 ~ 46V 54 ~ 60V
47 ~ 53V 59 ~ 65V
Shut down o/p voltage, re-power on to recover
UL8750 , ENEC EN61347-1, EN61347-2-13 independent, EN62384, J61347-1, J61347-2-13, (type”HL”) CSA C22.2 No.250.13-12,
IP67 approved ; Design refer to UL60950-1, TUV EN60950-1
161*61*36mm (L*W*H)
0.7Kg;20pcs/15Kg/0.73CUFT
File Name:LPF-90-SPEC 2017-04-14

Содержание

Похожие устройства

Скачать