![Daikin FXS80LVE [41/54] Natural evaporating pan type humidifier wiring adaptor is required](/img/pdf.png)
Daikin FXS80LVE [41/54] Natural evaporating pan type humidifier wiring adaptor is required
![Daikin FXS25LVE [41/54] Natural evaporating pan type humidifier wiring adaptor is required](/views2/1704179/page41/bg29.png)
(' $FFHVVRULHV
);6/
6
Natural Evaporating Pan Type Humidifier (Wiring adaptor is required.)
Specifications
Precaution at use
1. “Wiring adaptor (KRP1B61)” is separately needed for one indoor unit by one piece of the adaptor.
2. This humidifier will be built in a indoor unit, while the solenoid valve box will be mounted out of the unit's body
(refer to the dimensions of optional accessories).
3. The field setting should be changed by a remote controller.
Note:
The value in JIS heating condition's standard.
Feed water piping
1. Provide a stop valve of feed water for the feed water circuit.
2. Supply clean water for the feed water. Contaminated water clogs a valve and the contaminants accumulate in a
water tank, disturbing a normal operation of the humidifier. (Never use cooling water for a cooling tower or hot
water for heating purpose). Moreover, since white powder will appear if the feed water contains much silica, it is
recommended to install a water purifier or a water softener if these phenomena are found.
3. Use water in the range of water temperature 5 ~ 50°C and water pressure 0.049 ~ 0.294 MPa[0.5 ~3kg/cm²].
Provide a reducing valve between a strainer and this kit, in case of 0.294MPa or more for feed water pressure.
4. The feed water pipe can not be connected to a public water route. Accordingly, if water must be supplied through
a public water by all means, provide a cistern tank (approved model only).
Wiring diagram
Characteristics of Filter
Model
Item
KNM25K32V1 KNM25K50V1 KNM25K63V1 KNM25K125V1
Humidifying Capacity (L/h) 0.4 0.6 1.0 1.8
Power Supply (W) Single Phase, 220-240V 50Hz
Power Consumption 12/9.6
Water Inlet Port 1/2B
Water Outlet Port VP25 (External dia.
φ32) (drain pipe at indoor unit)
Applicable Models 20·25·32Class 40·50Class 63Class 80·100·125Class
------------- Field wiring
Make wiring as shown on the
right, if a humidity controller
will be mounted.
Arrange the wiring shown
right locally for that case. Set
the turn-over switch to OFF
for the choice of ON/OFF of
group humidity controlling
input on the "Wiring adaptor
PC board" .
Содержание
- Features 2
- Direct installation of half panel 3
- Example of installation built in 3
- Installation like ceiling mounted cassette type with high efficiency filter 3
- Installation of half panel and suction canvas 3
- Installation with duct a 3
- Ceiling return 4
- Installation with duct b 4
- Ceiling mounted built in type 5
- Specifications 5
- Ceiling mounted built in type 6
- Ceiling mounted built in type 7
- Dimensions 8
- Fxs20l bybs32djw1 with canvas duct fxs25l bybs32djw1 with canvas duct fxs32l bybs32djw1 with canvas duct 8
- Unit mm 8
- Fxs40l bybs45djw1 with canvas duct 9
- Unit mm 9
- Fxs50l bybs45djw1 with canvas duct 10
- Unit mm 10
- Fxs63l bybs71djw1 with canvas duct 11
- Unit mm 11
- Fxs80l bybs125djw1 with canvas duct 12
- Unit mm 12
- Fxs100l bybs125djw1 with canvas duct fxs125l bybs125djw1 with canvas duct 13
- Unit mm 13
- Fxs20l bybs32djw1 without canvas duct fxs25l bybs32djw1 without canvas duct fxs32l bybs32djw1 without canvas duct 14
- Unit mm 14
- Fxs40l bybs45djw1 without canvas duct 15
- Unit mm 15
- Fxs50l bybs45djw1 without canvas duct 16
- Unit mm 16
- Fxs63l bybs71djw1 without canvas duct 17
- Unit mm 17
- Fxs80l bybs125djw1 without canvas duct 18
- Unit mm 18
- Fxs100l bybs125djw1 without canvas duct fxs125l bybs125djw1 without canvas duct 19
- Unit mm 19
- Piping diagrams 20
- Refrigerant pipe connection port diameters 20
- Fxs 20l 25l 32l 40l 50l 63l 80l 100l 125lve 21
- Wiring diagrams 21
- Capacity tables 22
- Cooling capacity 22
- Refer to outdoor unit capacity tables on page 349 for the actual performance data of each indoor and outdoor unit combination 24
- Heating capacity 25
- Refer to outdoor unit capacity tables on page 415 for the actual performance data of each indoor and outdoor and outdoor unit combination 27
- Fan performances 28
- Air velocity and temperature distributions reference data 29
- Electric characteristics 31
- Notes 1 the operating conditions are assumed to be standard jis conditions 2 these operating values were obtained in a dead room conversion values sound level will vary depending on a range of factors such as the construction acoustic absorption coefficient of the particular room in which the equipments installed 32
- Overall 32
- Sound levels 32
- Octave band level 33
- Bolt pitch 34
- Center of gravity 34
- Drain pump kit 34
- Installation 34
- Service space 34
- 1 connect the drain hose to the drain raising pipes and insulate them 2 connect the drain hose to the drain outlet on the indoor unit and tighten it with the clamp 3 insulate both metal clamp and drain hose with the attached sealing pad 35
- Caution 35
- How to install piping 35
- If converging multiple drain pipes install according to the procedure shown below 35
- If the drain hose cannot be sufficiently set on a slope execute the drain raising piping to keep the drain hose from sagging space hanging wires every 1 to 1 m 35
- Insulate the drain hose inside the building 35
- Precautions for drain raising piping 35
- Select converging drain pipes whose gauge is suitable for the operating capacity of the unit 35
- Setting the unit at an angle opposite to the drain piping might cause leaks 35
- The diameter of the drain pipe should be greater than or equal to the diameter of the connecting pipe vinyl tube pipe size 25 mm outer dimension 32 mm 35
- Use the attached drain hose and clamp metal tighten the clamp firmly insert the drain hose into the drain socket up to the white tape tighten the clamp until the screw head is less than 4 mm from the hose 35
- When air inlet panel is directly installed 275 35
- When canvas duct is installed 350 530 35
- Wrap the attached sealing pad over the clamp and drain hose to insulate 35
- 2 after piping work is finished check drainage flows smoothly open the water inlet lid add approximately 1000 cc of water gradually and check drainage flow 36
- When electric wiring work is finished 36
- When electric wiring work is not finished 36
- Accessories 37
- Standard accessories 37
- Access panel 38
- Air discharge flange 38
- Air suction canvas 38
- Air suction flange 38
- Auxiliary electric heater 38
- Filter chamber for bottom suction 38
- Filter chamber for rear suction 38
- Half panel 38
- High efficiency filter 65 95 38
- Long life replacement filter 38
- Natural evaporating pan type humidifier 38
- Note 1 one adaptor for wiring krp1b61 per indoor unit is required if installing an electric heater or a natural evaporating pan type humidifier an electric heater cannot be used for vrv system cooling only 2 if installing a high filter in the ceiling mounted built in type an assembly chamber for either bottom or rear suction is required 38
- Optional accessories for controls refer to p 06 38
- Optional accessories for unit 38
- Screening door 38
- Access panel 39
- Cautions when the ceiling board is installed the decoration panel is not needed 39
- Dimension 39
- Install ceiling joist supports to fit the ceiling opening 39
- Installation before installation 1 make an opening on the ceiling 39
- Installation of the ceiling board the ceiling board can be installed into the inner frame assembly as follows 1 remove decoration panel retainer from the inner frame assembly 2 remove the decoration panel and substitute with the ceiling board 3 set the ceiling board by retainer removed in step 1 of above 39
- Specifications 39
- Auxiliary electric heater a wiring adaptor is needed 40
- Installation characteristics of filter 40
- Precaution at use 1 when the aux electric heater will be installed wiring adaptor krp1b61 is separately needed for one indoor unit by one piece of the adaptor 40
- Specifications 40
- Wiring 40
- Natural evaporating pan type humidifier wiring adaptor is required 41
- 65 type 90 type 42
- Characteristics of filter 42
- High efficiency filter 42
- Installation 42
- Specifications 42
- Can be used also as rear suction types 43
- Canvas duct air suction canvas 43
- Characteristics of filter 43
- Installation 43
- Long life replacement filter 43
- Note the filter models for 20 5 43
- Specifications 43
- Air discharge adaptor 44
- Characteristics of filter 44
- Specifications 44
- Suction panel 44
- Applicable model 45
- Be sure to remove the long life filter and attach the rear suction type s sealing plate there when the filter chamber for the rear suction type must be installed 45
- Filter chamber for rear suction type 45
- Installation 45
- Note refer to the appearance figure of optional accessory describing later for further details 45
- This kit will be used for the rear suction type when the high efficiency filter or the long life filter will be built in 45
- Applicable model 46
- Dimension 46
- Filter chamber for bottom suction 46
- Installation 46
- Note refer to the appearance figure of optional accessory describing later for further details 46
- Air suction flange 47
- Blind board screening door used for the rear suction type 47
- Dimension 47
- Example of installation 47
- Installation 47
- Kbbj25k36 56 80 160 specifications 47
- Specifications 47
- When this kit will be used the rear suction type s sealing plate will be required separately 47
- Dimensions with the optional accessories 48
- Fxs40l 50l 48
- Natural evaporating pan type humidifier discharge outlet adaptor fxs20l 32l 48
- External drawing with optional accessories natural evaporating type humidifier air discharge adaptor fxs63l 49
- Fxs80l 125l 49
- Fxs40l 50l 50
- High efficiency filter air discharge adaptor fxs20l 32l 50
- Fxs80l 125l 51
- High efficiency filter fxs63l 51
- Duct style installation fxs20l 32l 52
- Fxs40l 50l 52
- Duct style installation fxs63l 53
- Fxs80l 125l 53
Похожие устройства
- Daikin FXS80LVE Сервис мануал
- Daikin FXS100LVE Сервис мануал
- Daikin FXS100LVE Технические данные
- Daikin FXS125LVE Технические данные
- Daikin FXS125LVE Сервис мануал
- Zkteco BS-32B11D Техническое описание
- Zkteco ES-31A11A Техническое описание
- Zkteco ES-31A11E Техническое описание
- Zkteco ES-31A11J Техническое описание
- Zkteco ES-32B11A Техническое описание
- Zkteco ES-32B11E Техническое описание
- Zkteco ES-32B11J Техническое описание
- Zkteco BL-32C28L Техническое описание
- Zkteco BS-32E12K Техническое описание
- Zkteco BS-32E12K Инструкция
- Zkteco BS-32E13K Техническое описание
- Zkteco BS-32E13K Инструкция
- Zkteco DL-32C28B Техническое описание
- Zkteco EL-32C28I Техническое описание
- MEAN WELL PLC-100-12 Инструкция по эксплуатации