TRACO POWER TOP60316 [2/2] Installation instructions
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

TRACO POWER TOP60316 [2/2] Installation instructions

TRACO POWER TOP60105 [2/2] Installation instructions
http://www.tracopower.com Issued: 03.07.2009 / Rev. 1.1
Safety Instructions:
Before installation read these instructions carefully
and completely. This installation instruction cannot
claim for every possible example of installation,
operation or maintenance. Further information’s are
obtainable from your local distributor office or from
the product data sheet which can be downloaded
from the Internet at http://tracopower.com
.
The power supplies is a building-in component and
are constructed in accordance with the safety
requirements of IEC/EN/UL60950-1. They fulfil the
requirements of the Low Voltage Directive (LVD) and
carries the CE-mark. They are UL and cUL approved
in accordance with UL60950-1 (recognised).
Before any installation, maintenance or modification
work ensure that the main switch is switched off and
prevented from being switched on again. In case of
non-observance touching at any alive components
or improper dealing with this power supply can result
in death, severe personal injury or substantial
property damage. The successful and safe operation
is dependent on proper storage, handling,
installation and operation.
Compliance with the relevant national regulations (in
the USA, Europe and the other countries) of EN
60950-1/IEC 60950-1, UL 60950-1, must be ensured.
Before operation is started the following conditions
must be ensured:
Connection to mains supply in compliance with
national regulations (VDE0100 and EN50178).
The creepage distance, clearance and thickness
of insulation into a certain primary and ground as
well as primary and secondary circuits shall
comply with the current requirement of EN
60950-1/IEC 60950-1, UL 6950-1.
By use of stranded wires, all strands must be
fastened in the terminal blocks.
Power supply and mains cables must be
sufficiently fused.
Touch current shall not be higher as 3.5 mA
All output wires must be rated for the power
supply output current and must be connected
with the correct polarity.
This unit power supply must be connected to the
safety grounding before using.
Sufficient cooling must be ensured.
The power supply is intended to be used in
altitudes up to 3000M
Keep away from fire and water
Never work on the power supply if power is
supplied! Risk of electric arcs and electrical shock
which can cause death, severe personal injury or
substantial property damage.
Warning: Hazardous voltages and components
storing a very substantial amount of energy are
present in this power supply during normal operating
conditions. However, these are inaccessible. Im-
proper handling may result in an electric shock or
serious burns!
Installation Instructions:
This power supply is designed for professional
indoor systems. In operation the power supply must
not be accessible. It may be installed and put into
service by qualified personnel only.
The correct mounting position for optimal cooling
performance must be observed. Observe power
derating. (see data sheet)
Recycling: The unit contains elements which are
suitable for recycling, and components which need
special disposal. You are therefore requested to make
sure that the power supply will be recycled by the end
of its service life.

Содержание

Похожие устройства

Скачать