Biostar J4105TH Версия 6.x [17/29] Usb configuration

2. Advanced Menu | 17

J4105TH

USB Configuration

Legacy USB Support

The item allows you to enable Legacy USB support. AUTO opon disables legacy support if no USB

devices are connected. DISABLE opon will keep USB devices available only for EFI applicaons.

Opons: Enabled (Default) / Disabled / Auto

XHCI Hand-o

This is a workaround for OSes without XHCI hand-o support. The XHCI ownership change should

be claimed by XHCI driver.

Opons: Enabled (Default) / Disabled

USB Mass Storage Driver Support

The item allows you to enable or disable USB Mass Storage Driver Support.

Opons: Enabled (Default) / Disabled

USB transfer me-out

The me-out value for Control, Bulk, and Interrupt transfers.

Opons: 20 sec (Default) / 1 sec / 5 sec / 10 sec

Device reset me-out

The item sets USB mass storage device Start Unit command me-out.

Opons: 20 sec (Default) / 10 sec / 30 sec / 40 sec

Device power-up delay

Maximum me the device will take before it properly reports itself to the Host Controller.

“Auto” uses default value: for a Root port it is 100ms, for a Hub port the delay is taken from Hub

descriptor.

Opons: Auto (Default) / Manual

Note

The following items appear only when you set the Device power-up delay funcon to [Manual].