Planet WML-3565 Инструкция по эксплуатации онлайн [16/34] 65751

Network Type Infrastructure – This operation mode requires the presence of an

802.11 Access Point. All communication is done via the Access

Point or Router.

Ad-Hoc – Select this mode if you want to connect to another

wireless stations in the Wireless LAN network without through an

Access Point or Router.

TX Power If you want to lower the transmit power of the card for saving the

power of the system, you can select the lower percentages from

the list. The lower power will cause the lower signal strength and

the coverage range.

Ad Hoc Wireless Mode When the card is set in Ad Hoc (Peer to Peer Mode), you can

designate the wireless connection mode for the Ad Hoc network.

802.11 B only – This card can be compatible with both 802.11g

and 802.11b wireless stations. If there are only 802.11b wireless

stations in the network, you can set the card to this mode.

802.11 B/G mix – If you have a mix of 802.11b and 802.11g

wireless stations in your network, it is recommended to setting the

card to this mode. This mode is also the default setting.

802.11 G only – This card can be compatible with both 802.11g

and 802.11b wireless stations. If there are only 802.11g wireless

stations in the network, you can set the card to this mode.

Preamble The preamble defines the length of the CRC block for

communication among wireless devices. This option is only active

in the Ad Hoc network.

There are two modes including Auto and Long Preamble. If

“Auto“ mode is selected, the card will auto switch the preamble

mode depending on the wireless devices the card is connecting

to.

RTS Threshold Minimum packet size required for an RTS (Request To Send). For

packets smaller than this threshold, an RTS is not sent and the

packet is transmitted directly to the wireless network. Select a

setting within a range of 0 to 2347 bytes. Minor change is

recommended.

Fragment Threshold The value defines the maximum size of packets; any packet size

larger than the value will be fragmented. If you have decreased

this value and experience high packet error rates, you can

increase it again, but it will likely decrease overall network