Planet WNL-9320 Инструкция по эксплуатации онлайн [16/41] 65801

- 12 -

Ad-Hoc – Select this mode if you want to connect to another wireless station in the

Wireless LAN network without through an Access Point or Router.

TX Power If you want to lower the transmit power of the card for saving the power of the system,

you can select the lower percentages from the list. The lower power will cause the

lower signal strength and the coverage range.

Ad Hoc Wireless Mode When the card is set in Ad Hoc (Peer to Peer Mode), you can designate the wireless

connection mode for the Ad Hoc network.

802.11 B only – This card can be compatible with both 802.11g and 802.11b wireless

stations. If there are only 802.11b wireless stations in the network, you can set the

card to this mode.

802.11 B/G mix – If you have a mix of 802.11b and 802.11g wireless stations in your

network, it is recommended to setting the card to this mode. This mode is also the

default setting.

802.11 G only – This card can be compatible with both 802.11g and 802.11b wireless

stations. If there are only 802.11g wireless stations in the network, you can set the

card to this mode.

Preamble The preamble defines the length of the CRC block for communication among wireless

devices. This option is only active in the Ad Hoc network.

There are two modes including Auto and Long Preamble. If “Auto“mode is selected,

the card will auto switch the preamble mode depending on the wireless devices the

card is connecting to.

RTS Threshold Minimum packet size required for an RTS (Request To Send). For packets smaller

than this threshold, an RTS is not sent and the packet is transmitted directly to the

wireless network. Select a setting within a range of 0 to 2347 bytes. Minor change is

recommended.

Fragment Threshold The value defines the maximum size of packets; any packet size larger than the value

will be fragmented. If you have decreased this value and experience high packet error

rates, you can increase it again, but it will likely decrease overall network

performance. Select a setting within a range of 256 to 2346 bytes. Minor change is

recommended.

Channel This setting is only available for Ad Hoc mode. Select the number of the radio channel

used for the networking. The channel setting should be the same with the network you

are connecting to.