Ardesto OFH-11X1 [8/12] Instructions for use

1. Place the radiator body upside-down on a scratch-free location, make sure it is stable

and will not fall.

2. Screw o the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to

the U-facing ange between rst and second ns (near the front cover).

3. To attach the castor mounting plate to the radiator body, you should insert the threaded

ends of the U bolt in the holes on the castor mounting plate.

4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.

Note: do not over tighten, which may cause the damage of radiator ange.

5. Screw o spherical nut from the castor, align the shaft to the hole of the castor mounting

plate, insert in, and screw on the spherical nut.

6. Repeat 2, 3, 4 and 5 on the rear of radiator for mounting of the rear castors.

Note: the rear castors must be mounted between the end two ns.

INSTRUCTIONS FOR USE

1. Before using the heater, make sure that it is on a at and stable surface, damage may

occur if it is placed on an incline or decline.

2. Set all the controls to OFF position and insert the plug into a socket-outlet with well

grounded. Be sure that plug ts rmly.

3. Rotate the thermostat knob clockwise to MAX position and switch the heater on as

follow: the switch I for low heat, the switch II for medium heat and both switches on for

high heat.

4. When your room reaches the desired temperature, now slowly rotate the thermostat

knob counter clockwise until the pilot light goes out. The thermostat can now be left at

this setting. As soon as the room temperature has dropped below the set temperature,

the unit will switch it self on automatically until the set temperature has been reached

again. In this way the room temperature remains constant with the most economical use

of electricity.