Home
Главная
Raijintek
Другое
SAMOS AD5700 RBW
Руководство по установке Страница: 1

Raijintek SAMOS AD5700 RBW Руководство по установке онлайн

Creating Passion

1.Keep and store the product away from the reach of children.

2.Check the component list and condition of the product

before installation. If there is any problem, contact the shop

where you purchased to get a replacement or refund.

3.RAIJINTEK Co., Ltd. is not responsible for any damages due

to external causes, including but not limited to, improper use,

problems with electrical power, accident, neglect, alteration,

repair, improper installation, and improper testing.

4.GPU and VGA card are subject to damage if the product in

incorrectly installed.

5.This product is a water cooling solution device, once taken

apart or any use of non RAIJINTEK’s accessories, will lead to

a warranty loss.

6.Liquid contaminations of other objects are in no matter

under warranty due to maintenance or possible misuse.

Precautions

SAMOS SERIES LIQUID COOLING GRAPHIC CARD WATER BLOCK

Remove the screws circled on the

diagram. All Back-plate and Heat-sink

assembly screws should be removed

Remove the power connector of fan,

and carefully detach the original stock

cooler

SAMOS

AD5700 RBW

Thermal pad × 4

VGA water block × 1

3 4

Back plate × 1

M2 L6 screw × 10

M2 L10 screw for back plate × 6

Washers × 15

Thermal Grease × 1

Clean the original thermal

grease off

the GPU die and

thermal pad.

Apply Thermal grease on GPU

evenly.

Cut the thermal pads to place on the

heat-emanating chips.

Precaution: Besides GPU that needs

to have thermal grease applied on it, the

heat emanating chip on the VGA card

also needs the thermal pads to be

attached on it, or the card will burn out.

Connect to MB 5V ADD Header Connect to RJK RBW-ADD

Control Hub

Stick the VGA water block on

the VGA card. Align the screws

onto the screw holes on the

VGA card. Pay attention to

the pressure applied during

installation. Do not press the

VGA water block and PCB

board too hard.

Precaution:

Fasten the

screws until the VGA water

block is balanced. To avoid

damaging the chip, do not

fasten the screws to the point

where it cannot be

screwed

anymore.

Fasten the spring screw from

backside (Place the insulation

washer on the screw hole)

Once installing VGA water

block is done, place the back

plate and fasten the screws on

it.

OUTIN

MODE

SPEED

MODE

AUTO

SPEED

RF Wireless

Raijintek SAMOS AD5700 RBW Руководство по установке онлайн

Содержание

Похожие устройства