Trendnet TEW-692GR [13/20] Click internet protocol tcp ip and then click properties then click on obtain an ip address automatically

2. I am not sure what type of Internet Account Type I have for my Cable/DSL connection.

How do I find out?

Contact your Internet Service Provider's (ISP) support service for the correct information.

3. I configured my router with my ISP settings, but I cannot get onto the Internet. What

should I do?

1. Verify that you can get onto the Internet with a direct connection into your modem.

2. Contact your ISP and verify all the information that you have in regards to your Internet

connection settings is correct.

3. Power cycle your modem and router. Unplug the power to the modem and router. Wait

30 seconds, and then reconnect the power to the modem. Wait for the modem to fully

boot up, and then reconnect the power to the router.

4. All the settings are correct, but I cannot make a wireless connection to the Router. What

should I do?

1. Double check that the WLAN light on the Router is lit.

2. Power cycle the TEW-692GR. Unplug the power to the router. Wait 30 seconds and then

reconnect the power to the router.

3. Contact the manufacturer of your wireless network adapter and make sure the wireless

network adapter is configured with the proper SSID. The default SSID of the TEW-692GR

is TRENDnet692_2.4GHz and TRENDnet692_5GHz. If you have enabled any encryption

on the TEW-692GR, make sure to configure the wireless network adapter with the same

wireless security password.

5. When I connect a computer to the router's LAN port, I am not getting Gigabit speeds.

What should I do?

1. Make sure that you have a Gigabit Ethernet adapter installed.

2. Make sure to use a Cat-5e or Cat 6 network cable. Some CAT-5 cables are not rated to

run in Gigabit.

2. Click Internet Protocol (TCP/IP) and then

click Properties. Then click on Obtain an IP

address automatically.

Windows XP/2000

1. Go into the Control Panel, double-click the

Network Connections icon and then

right-click the Local Area Connection icon

and then click Properties.