Grundig SIS 8250 [8/13] Fillinginthewatertank

Grundig SIS 8250 [8/13] Fillinginthewatertank
18
ENGLISH
OPERATION _________________________________
7 After the ironing process is complete, place the
iron onto the storage base.
8 Press and hold down the on/off switch of the
steam ironing station for a few seconds to
switch the steam ironing station off. Set the tem-
perature control dial to MIN and disconnect
the plug from the power outlet.
The red power indicator light
N
and the
blue steam button indicator light LOW
P
go
off.
9 Let the appliance cool down in a location that
is safely out of reach of children.
Filling in the water tank
1 Grab the handle
V
underneath the water tank
and pull the water tank out of the steam iron.
2 Open the lid of the water filling opening
F
and fill the water tank with tap water or distilled
water up to the MAX marking. The maximum
capacity is 1.7 litres.
3 Close the lid of the water filling opening and
push the water tank completely into the steam
ironing station. Make sure that it clicks into
place properly and is secured to the housing of
the steam ironing station.
Caution
7
Do not move or shake the steam ironing sta-
tion when the water tank is being filled. Water
might spill out from the opening of the water
tank.
4 Press the steam jet button briefly to reset the
iron. After about 10 seconds the iron will be
ready for steam ironing.
Notes
7
When the water tank is empty, air enters into
the pump causing a louder ‘pumping’ sound.
This is quite normal.
7
If your tap water is very hard it is recom-
mended to mix the tap water with distilled
water on a 50:50 ratio, or use distilled water
only.
Steam ironing
1 Place the appliance on an even, dry and non-
slip surface. The non-slip feet
U
ensure the sta-
bility of the appliance.
2 Fill the water tank as described in the section
“Filling in the water tank”.
3 Insert the power plug
B
into the wall socket.
4 Push the on/off switch
S
to switch on the
steam ironing station.
The power indicator
N
lights up red and the
blue steam button indicator light blinks on
LOW
P
.
5 Adjust the temperature control dial
G
to the
desired temperature.
The temperature indicator light
K
lights up
blue. The blue temperature indicator light
K
remains on while the iron is heating up. As
soon as the iron reaches the set temperature,
the temperature indicator light goes off. The
temperature indicator light will go on and
off during usage to indicate that the set tem-
perature is being regulated.
Note
7
Steam ironing is only possible at higher tem-
perature settings between •• and MAX.
6 The water in the water tank heats up within 3
minutes. As soon as the temperature indicator
light goes off and the control indicator in the
steam button remains lit, the steam iron is ready
to use. Hold the iron in horizontal position on
the garments and press the steam jet button
H
.
Continue to move the iron when ironing.
Caution
7
Never direct the steam at people or pets.
Notes
7
When the steam ironing station is switched on
it will produce a 'pumping' sound. This is nor-
mal and indicates that water is being pumped
from the water tank into the steam ironing
station.
Скачать
Случайные обсуждения