Vitek VT-1352 [4/14] English

ENGLISH

POWER SCREW

" The power screw permits you to adjust the power. It

has been adjust before leaving the factory.

However, if the voltage in your home is low, you may

need to readjust it.

 To adjust, use a screwdriver or a thin coin to turn

power screw in clockwise direction until the arm

strikes the coil, making a noise. Then slowly turn

power screw out (counterclockwise) just until

noise stops. This is maximum power setting.

BLADE LEVER

 The lever is conveniently located near your thumb

(if you're righthanded) so it can easily be adjusted

while the clipper is in your hand.

 The lever adds versatility to your clipper by allowing

you to gradually change the closeness of your cut

without an attachment comb.

 When the lever is in the uppermost position, the

blades will give you the closest cut and leave the

hair very short. Pushing the lever downward gradu

ally increases the cutting length.

 In its lowest position, the lever will leave the hair

approximately the same

length as a N1 comb.

 The lever will also extend the

use of your blades since a dif

ferent cutting edge is used in

each , setting.

1352.qxd 07.02.03 11:16 Page 8