Timberk TAP FL700 MF (BL) [6/24] Transportation and storage

Timberk TAP FL700 MF (BL) [6/24] Transportation and storage
In case of emergency contact information listed in the table 2 below. If you
can not solve problems independently, to a service center.
8. TROUBLESHOOTING
Table 2
Problem Check Solution
Appliance does not turn ON
• Power
• Power
• Cover
• Plug in power cord
*Press the power button
*Make sure the cover is securely closed
Red «CLEAN CELL» indicator
has illuminated
Collector cell
Red «CLEAN CELL» indicator is a 60 day cleaning
reminder. Wash collector cell. Make sure it is
thoroughly clean before reinstalling
Red «CLEAN CELL» indicator
is blinking
Collector cell
• When a large particle is captured in the collector cell,
please restart your appliance
• A fast blinking light indicates the power supply has
shut down due to arcing or short circuit. The cell
should be inspected and cleaned, repaired, or replaced
Collector cell does not remove
particles
Collector cell
• Clean the collector cell
• Collector cell may be damaged. Contact authorized
service center
Appliance sparks, crackles
and pops
Collector cell
• Sparking or poping noise (arcing)can occur when
a large particle is captured in the collector cell or
appliance is used in over damp rooms. If the appliance
is arcing excessively, the cell may be dirty. Try cleaning
the collector cell.
• If excessive arcing continues after proper cleaning,
the collector cell may be damage. If damager, contact
authorized service center.
«AUTO» light is blinking
Surroundings
Air qulity is very bad, please open the window to
improve the ventilation
Odor sensor
Odor sensor get malfunction, should be repaired or
replaced
Term reliability is 5 years.
At the end of the life of the puripier should be subjected to disposal in
accordance the rules, regulations and methods, at the place of disposal.
9. UTILIZATION
10. TRANSPORTATION AND STORAGE
4.Thoroughly rinse the pre-filter and let it air dry before placing it back in the
cabinet. Do not use heated or compressed air as part of the drying process.
5.Slide the pre-filter back into the unit.
6.Close the front cover securely.
Cleaning the Exhaust Grille
1. Remove the cleaning brush from the storage slot located under the cover.
2. Brush away debris that has collected between the grille slots.
3. Return the cleaning brush to the storage slot.
1. When transporting, any possible impacts and movements of the
package inside a vehicle must be avoided.
2. Handling symbols on the unit’s package must be strictly observed when
transporting and storing it.
3.
Temperature
requirements*
Humidity
requirements*
Transportation and
storage
-30°C to +50°C
15% to 85%
(no condensate)
We are researching new technologies and constantly improving the quality
of our products. Specifications, design and scope of delivery may be
changed without any prior notice.
* Products must be stored in dry, ventilated storages at the temperature
not lower than +5°C.
www.timberk.com • air purifier
6

Содержание

Скачать