Kuppersberg Slimlux S 60 GB Инструкция по эксплуатации онлайн [9/28] 588001

Содержание

Похожие устройства

ENGLISH TECHNICAL PASSPORT Cooker hood USE The hood is designed to be used ei ther for exhausting or filter version DUCTING VERSION In this case the fumes are conveyed outside of the building by means of a special pipe connected with the con nection ring Located on top of the hood Attention The exhausting pipe is not supplied and must be purchased apart Diameter of the exhausting pipe must be equal to that of the connection ring In the horizontal runs the exhaust ing pipe must be slightly slanted about 10 and directed upwards to vent the air easily from the room to the outside Attention If the hood is supplied with active charcoal filter then it must be removed Connect the hood and discharge holes on the walls with a diameter equivalent to the air outlet connection flange Using the tubes and discharge holes on walls with smaller dimensions will cause a diminution of the suction per formance and a drastic increase in noise Any responsibility in the matter is therefore declined Use a duct of the minimum indispensible Length Use a duct with as few elbows as possible maximum elbow angle 90 Avoid drastic changes in the duct cross section Use a duct as smooth as possible inside The duct must be made of certi fied material FILTER VERSION One active charcoal filter is needed for this and can be obtained from your usual retailer The filter removes the grease and smells from the extracted air before sending it back into the room through the upper outlet grid INSTALLATION The minimum distance between the supporting surface for the cooking equipment on the hob and the Lowest part of the range hood must be not Less than 45cm from electric cookers and 50cm from gas or mixed cookers If the instructions for installation for the gas hob specify a greater distance this must be adhered to ELECTRICAL CONNECTION The mains power supply must corre spond to the rating indicated on the plate situated inside the hood If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area after installation If it not fitted with a plug direct mains connection or if the plug is not Located in an accessible area after installation apply a double pole switch in accordance with standards which as sures the complete disconnection of the mains under conditions relating to over current category III in accordance with installation instructions O Warning Before re connecting the hood circuit to the mains supply and checking the efficient function al ways check that the mains cable is cor rectly assembled The hood is provided with a special power cable if the cable

Скачать