Candy BCBF 50 NUK [12/14] Precautions for the correct operation

Once the product has been embedded, place the rear part of

the column in contact with the wall so as to prevent access to the

compressor compartment.

For the product to operate correctly it is essential to allow adequate air

circulation so as to cool down the condenser located in the rear part

of the appliance.

For this reason, the column must be equipped with a rear chimney,

whose upper opening must not be bloc

ked and with a

front slot which

will be covered with a ventilation grill.

The appliance is equipped with coupling devices for the appliance

doors with the column panels (loader slide).

COUPLING OF THE PANELS OF THE

BUILT-IN COLUMN OF THE APPLIANCE

DOORS

Secure the slide in the inner part of the panel of the built-in column at the

desired height and at approx. 20 mm. From the outer wire of the door.

Open the doors of the built-in column and the fridge. Position the built-in

loader in the slide, then fit it into the fridge door.

Mark the fixing points for the screws and drill with a bit of a

diameter of 2.5mm.

Connect the appliance door to the cabinet panel keeping the

loader slots as guidelines.

PRECAUTIONS FOR THE CORRECT

OPERATION

SUSPENDING USE OF THE APPLIANCE

If the appliance is not to be used for a long time:

1) Turn the appliance OFF (see Operation).

2) Extract the plug or remove the safety device.

3) Clean the appliance

4) Leave the doors of the appliance open.

EN 11