Home
Главная
Candy
Холодильник
FR CPD401FVX
Инструкция по эксплуатации Страница: 26

Candy FR CPD401FVX [26/67] General information

GENERAL INFORMATION

1) Carefully read the instructions contained in this handbook since they provide important

information relative to safety during installation, use and maintenance.

Keep this handbook carefully for future reference.

2) Once the appliance has been unpacked make sure that it is undamaged.

This appliance should be used only for the purpose for which it was specifically designed,

namely for the conservation of foodstuffs.

Any other use is considered unsuitable, and thus dangerous.

The manufacturer declines all responsibility for any damage that may be caused by

unsuitable, incorrect or unreasonable use.

Send off the warranty certificate.

Declaration of compliance: the parts of this appliance that may come into contact with

foodstuffs comply with the provisions of EEC Directive 89/109.

This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes.

HOW TO USE THE REFRIGERATOR

Electrical connection

This refrigerator is set to work at the nominal voltage indicated on the rating plate inside

the product. Voltage fluctuations should not be greater or less than 10% of the nominal

voltage.

Before connecting the appliance ensure that the data to be found on the rating plate is the

same as the mains supply. The rating plate is to be found inside the product.

In the case of incompatibility between the socket and the plug of the appliance have the

socket replaced with another, suitable one by a qualified electrician, who will also verify

that the capacity of the socket wiring is adequate for the power absorbed by the appliance.

The use of multiple socket adapters and/or extension cables is not recommended. The

supply socket of the refrigerator must be properly earthed. This fundamental safety requi-

rement must be verified and, if there are any doubts, the installation should be thoroughly

checked by a professional electrician.

The manufacturer declines all responsibility for any damage caused by the appliance not

being earthed.

INSTALLATION

For models where the feet are not already fitted, screw these into the relative threaded

holes under the refrigerator. Ensure that the two front feet are not quite fully screwed

home, so that the refrigerator leans slightly backwards.

Fig. 4: In the models where it exists, remove the door support cap (it is only necessary

during transportation) located on the bottom left hinge.

Where applicable, fit the appropriate spacers (fig. 1) in order to obtain proper air circula-

tion between the refrigerator and the wall behind: it is also recommended not to block any

ventilation or heat dispersal openings or grilles, leaving a space of at least 5 cm.

Do not install the refrigerator close to sources of heat. Furthermore, do not install the refri-

gerator anywhere where the temperature will be below +16°C or above +38÷43°C for

long periods.

Should the cabinet be installed below a wall unit a minimum gap of a 5 cm must be left

Содержание

Похожие устройства

GENERAL INFORMATION 1 Carefully read the instructions contained in this handbook since they provide important information relative to safety during installation use and maintenance Keep this handbook carefully for future reference 2 Once the appliance has been unpacked make sure that it is undamaged This appliance should be used only for the purpose for which it was specifically designed namely for the conservation of foodstuffs Any other use is considered unsuitable and thus dangerous The manufacturer declines all responsibility for any damage that may be caused by unsuitable incorrect or unreasonable use Send off the warranty certificate Declaration of compliance the parts of this appliance that may come into contact with foodstuffs comply with the provisions of EEC Directive 89 109 C This appliance complies with Directives 89 336 EEC 73 23 EEC and following changes HOW TO USE THE REFRIGERATOR Electrical connection This refrigerator is set to work at the nominal voltage indicated on the rating plate inside the product Voltage fluctuations should not be greater or less than 10 of the nominal voltage Before connecting the appliance ensure that the data to be found on the rating plate is the same as the mains supply The rating plate is to be found inside the product In the case of incompatibility between the socket and the plug of the appliance have the socket replaced with another suitable one by a qualified electrician who will also verify that the capacity of the socket wiring is adequate for the power absorbed by the appliance The use of multiple socket adapters and or extension cables is not recommended The supply socket of the refrigerator must be properly earthed This fundamental safety requi rement must be verified and if there are any doubts the installation should be thoroughly checked by a professional electrician The manufacturer declines all responsibility for any damage caused by the appliance not being earthed INSTALLATION For models where the feet are not already fitted screw these into the relative threaded holes under the refrigerator Ensure that the two front feet are not quite fully screwed home so that the refrigerator leans slightly backwards Fig 4 In the models where it exists remove the door support cap it is only necessary during transportation located on the bottom left hinge Where applicable fit the appropriate spacers fig 1 in order to obtain proper air circula tion between the refrigerator and the wall behind it is also recommended not to block any ventilation or heat dispersal openings or grilles leaving a space of at least 5 cm Do not install the refrigerator close to sources of heat Furthermore do not install the refri gerator anywhere where the temperature will be below 16 C or above 38 43 C for long periods Should the cabinet be installed below a wall unit a minimum gap of a 5 cm must be left 26

Скачать