Entel HT883 [5/24] Battery care information
![Entel HT883 [5/24] Battery care information](/views2/1076806/page5/bg5.png)
4
Common
Battery care / information
• Do not immerse the battery unless attached securly
to the radio in water or get it wet by other means
• Do not charge the battery near fires or under
direct sunlight
• Use only the specified charger and observe charging
requirements
• Do not pierce the battery with any object or strike
it with an instrument
• Do not use the battery pack if it is damaged in any
way
• Do not reverse-charge or reverse-connect the
battery
• Do not touch a ruptured or leaking battery
If liquids from the battery get into your eyes,
immediately:
• Wash your eyes out with fresh water avoiding
rubbing them.
• Seek medical treatment.
Battery Pack
• If a battery is not to be used for an extended
period of time (e.g. several months) remove the
battery pack from the equipment and store in a
cool and drylocation (around 0°C) part charged.
Do not fully discharge the battery before storage
.
• Each charge cycle reduces the battery’s life.
Minimise the number of times you charge your
battery especially in hotter environments which
further shortens a battery’s life.
The battery pack has an over-current protection
circuit fitted. When charging a completely discharged
battery i.e. first charge, ensure the battery is removed
from the radio and then re-attached (if fitted to radio
when charging). This will reset the protection circuitry
and ensure normal operation. This process will need to
be repeated if the battery is allowed to completely
discharge in the future. In normal use this is unlikely.
Battery Communications
Each battery used with your radio has a
microprocessor fitted, which logs the number of times
your battery has been charged.
On a radio with an LCD display, the number of times
the battery has been charged, together with the
remaining charge cycles available, will be shown during
switch on (if not de-activated by your dealer).
The warranty on all batteries is 12 months or 450
charge cycles, whichever is the sooner. After 420
cycles, at switch on the radio will emit a series of short
tones, and on LCD models a waste bin icon will flash
to alert you to the need to buy a new battery.
After 450 cycles, at switch on the radio will emit
aseries of long beeps, and on LCD models the message
will change to BATTERY COUNT EXCEEDED
REPLACE BATTERY. The radio will continue to
operate but its operational time may be reduced,
eventually failing all together.
Note: only genuine Entel batteries should be used.
Only genuine batteries offer the battery charge count
feature informing you when the battery is reaching the
end of its useful life. Non ATEX batteries will not work
on ATEX radios ensuring customer safety. Customer
satisfaction is assured as you can not be supplied with
sub standard, potentially dangerous battery packs from
3rd party manufacturers, ensuring it delivers the
expected capacity and endurance. On HT series
batteries a breathable membrane is used. This is clearly
marked on the battery label.
Piercing the membrane will allow water ingress to the
battery and will invalidate the warranty.
Содержание
- User guide ht800 series 1
- Common information all models page 2
- Ht802 812 822 882 u 2
- Ht802s 812s 822s 882s u 2
- Ht803 813 823 883 u 2
- Ht805 815 825 885 u 2
- Ht806 816 826 886 u 2
- Introduction 2
- Table of contents 2
- This guide covers the basics of your radio s operation to meet your exact requirements the radio may have been customised by your entel authorised dealer these features will be explained in a separate guide issued by the dealer 2
- Certification 3
- Declaration of conformity 3
- M austin 3
- Quality manager 3
- Battery care 4
- Battery pack precautions 4
- Common 4
- Introduction 4
- Radio care 4
- Battery care information 5
- Common 5
- Audio accessory options 6
- Battery charger options 6
- Carry options 6
- Common 6
- Note the use of non entel approved accessories will invalidate your atex intrinsically safe approval refer to certificate sira 10atex 2066x for permitted accessories 6
- Optional accessories 6
- Packing list 6
- Attaching removing the battery pack 7
- Attaching removing the belt clip 7
- Optional accessories 7
- Preparing your radio for use 7
- Attaching removing audio accessories 8
- Attaching removing the aerial 8
- Charging your radio 8
- Common 8
- Preparing your radio for use 8
- Turn your radio on by pressing the on off button on the front of the radio the radio will bleep and the led will illuminate constant yellow for approximately 4 seconds followed by a second warble if not disabled by the dealer when programmed 8
- Turning your radio on 8
- Dealer programmable features 9
- Ht802 812 822 882 u 9
- Standard features 9
- Channel scan control antenna 10
- Controls indicators 10
- Dealer programmable button 1 10
- Dealer programmable button 2 10
- Dealer programmable button 3 10
- Led indicator 10
- Microphone 10
- On off 10
- Push to talk ptt button 10
- Speaker 10
- Volume control 10
- Dealer programmable features 11
- Ht802s 812s 822s 882s u 11
- Ht8x2s 11
- Standard features 11
- Antenna 12
- Channel scan contact control 12
- Controls indicators 12
- Dealer programmable button 1 12
- Dealer programmable button 2 12
- Dealer programmable button 3 12
- Led indicator 12
- Microphone 12
- On off 12
- Push to talk ptt button 12
- Speaker 12
- Volume control 12
- Ht803 813 823 883 u 13
- Standard features 13
- Controls indicators 14
- Dealer programmable features 15
- Ht805 815 825 885 u 15
- Standard features 15
- Antenna 16
- Controls indicators 16
- Dealer programmable button 1 16
- Dealer programmable button 2 16
- Dealer programmable button 3 16
- Dealer programmable multi function buttons 16
- Led indicator 16
- Microphone 16
- Multi function control 16
- On off 16
- Push to talk ptt button 16
- Speaker 16
- Lcd indicators 17
- Dealer programmable features 19
- Ht806 816 826 886 u 19
- Standard features 19
- Antenna 20
- Controls indicators 20
- Dealer programmable button 1 20
- Dealer programmable button 2 20
- Dealer programmable button 3 20
- Dealer programmable multi function buttons 20
- Keypad 20
- Led indicator 20
- Microphone 20
- Multi function rotary control 20
- On off 20
- Push to talk ptt button 20
- Speaker 20
- Lcd indicators 21
- Certification 22
- Choice 24
- Professional s 24
Похожие устройства
- Flama FL-RC5 Инструкция по эксплуатации
- Gefest 3200 К2 Инструкция по эксплуатации
- Entel HT883–U Инструкция по эксплуатации
- Flama FL-UNV Инструкция по эксплуатации
- Gefest 3200 Инструкция по эксплуатации
- Entel HT844 Инструкция по эксплуатации
- Gefest 3200 К20 Инструкция по эксплуатации
- Entel HT844 ATIS Инструкция по эксплуатации
- Canon IXUS 125 HS Green Инструкция по эксплуатации
- Gefest 3200-03 Инструкция по эксплуатации
- Entel HT912 Инструкция по эксплуатации
- Canon IXUS 125 HS Pink Инструкция по эксплуатации
- Gefest 3200-04 Инструкция по эксплуатации
- Entel HT922 Инструкция по эксплуатации
- Canon IXUS 240 HS Pink Инструкция по эксплуатации
- Gefest 3200-05 К19 Инструкция по эксплуатации
- Entel HT982 Инструкция по эксплуатации
- Canon IXUS 500 HS Blue Инструкция по эксплуатации
- Gefest 3200-05 К20 Инструкция по эксплуатации
- Entel HT982-U Инструкция по эксплуатации