P.I.T. PBS75-C1 — общие меры безопасности при использовании электроинструментов [2/22]

RIX BELT SANDER GENERAL SAFETY PRECAUTIONS Before turning on check that the voltage of your power tool matches the mains voltage check the serviceability of the cable plugs and sockets in case of failure of these parts further operation is prohibited Power tools with double insulations do not need to be connected via a socket with grounded third wire For power tools without double insulation the connection through a socket with a grounded wire is mandatory Avoid body contact with grounded surfaces such as pipes radiators headings and refrigerators The electric shock risk sharply increases if your body comes into contact with a grounded object If the use of power tools in damp places is unavoidable the current feed to the power tool must be through a special interrupter device with a disconnecting power tool in case of leakage Rubber electrician gloves and special shoes will increase your personal safety Do not expose power tools to rain or wet conditions Water entering a power tool significantly increases the electric shock risk Handle the cable carefully Never use the cable to carry power tools or pull the plug from the socket Keep cord away from heat oil sharp edges or moving parts Replace damaged cables immediately Damaged cables increase the electric shock risk When the power tool is used outdoors use power extenders specifically designed for outdoor use Be careful keep an eye on what you are doing and use common sense when working with power tools Do not use the power tool while you arc tired or under the influence of drugs or deterrents as well as alcohol or drugs This can lead to serious injury Wear appropriate clothing Too loose clothing apparels or long loose hair can get into moving parts of a working electric tool Keep your hair clothing and gloves away from moving parts Hands should be dry clean and free of traces of oily substances Avoid accidental activation Make sure that the on off control is in the OFF position before turning on the power tool Do not carry power tools when your finger is placed on the on off control Remove the adjusting and or setting wrenches before turning on the power tool The abandoned wrench get caught up in the moving parts of the power tool may result a power tool damage or serious injury Keep your balance Use a good support and always keep the balance of the body securely Proper support and balance allows you to control the power tool in unexpected situations Use protective equipment to ensure your safety Always wear safety glasses A respirator non skid safety shoes a helmet and or headphones should be used for the appropriate conditions