STELS 51116 [12/28] Abrupt lowering can lead to the fall of the car from the jack and injure the operator

HYDRAULIC BOTTLE JACK ENG A ATTENTION Abrupt lowering can lead to the fall of the car from the jack and injure the operator After the car has been completely and stably lowered on the wheels wait till the pressure pad of the jack is removed from the counterpart of the car Then remove the jack lower the rod completely and close the release valve by turning it with the jack handle clockwise against the stop MAINTENANCE AND CARE Lubricate moving parts of the jack regularly main rod pump rod Use any engine oil for lubrication Do not use gasoline kerosene solvents or abrasive substances for cleaning the jack They can damage rubber seals which will cause oil leaks Store the jack on an even surface in a clean and dry place The jack rod should be fully down the release valve fully closed The product should be repaired only by qualified specialists of the service centres TROUBLESHOOTING CHART Symptom Possible cause Insufficient oil level Air accumulated in the jack system I Turn the release valve counterclockwise by one full turn 2 Insert the handle into the pump socket and turn it by six full turns 3 Turn the release valve clockwise to the stop to close it 4 Continue swinging the pump handle until the rod is in the maximum top position and swing it for some more time to remove air from the system 5 Open oil filler plug slightly with care to release accumulated air 6 Turn the release valve counterclockwise by one full turn lower the rod to the lowermost position If necessary use force 7 Close the release valve clockwise to the stop and check the functionality of the jack If necessary repeat the above actions once again The oil level exceeds the permissible value Check the level if necessary remove the oil filler plug and drain the excess oil The jack does not lift or lower a load The jack cannot be lowered completely Corrective action Check the oil level with following the instruction I Turn the release valve counterclockwise to lower the rod completely If the rod does not go down use force 2 Remove the oil filler plug The oil level should be at the level of the bottom point of the oil filler If the level is lower add oil to the necessary level Use only the recommended oil 3 Re install the oil filler plug back 4 Close the release valve and move the jack rod up and down completely several times It will distribute the oil completely within the whole system In the most cases it helps to recover the operation of the product 6 Check the operation of the jack