Denzel RHV-1100-26 (26610) [10/28] Rotary hammer
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Denzel RHV-1100-26 (26610) [10/28] Rotary hammer

Denzel RHV-1100-26 (26610) [10/28] Rotary hammer
9
ROTARY HAMMER
EN
a brush. When noticeable sparks appear, contact an authorized service center for diagnostics and replacement
of carbon brushes if necessary.
• To prevent dust and grease leakage this Electrical Rotary Hammer has a hermetic design. Therefore, the tool
can be used for a long time and you have no need to replace or add grease. After initial commissioning change
lubrication every 6 months of operation.
• Clean the tool holder box every time after use.
• In case of any damage to the power cord turn o the Electrical Rotary Hammer immediately, carefully, without
touching the places of damage, disconnect it from the mains.
ATTENTION!
Electrical Rotary Hammers use power cord with mounting type Y: for security it must be replaced by
authorized repair shop personnel.
Possible faults
Fault Probable cause Problem solution
When turning on the Electrical
Rotary Hammer, there is no
impact or rotation of the tool.
Damaged gear or impact mechanism. Call the service center.
At turning on the electric
motor does not work (line
voltage available).
Damaged switch or plug.
Call the service center.
Broken power cord or mounting wire.
Brush or collector malfunction.
Circular re on the collector.
Damage in the armature winding.
Call the service center.
Wearout /”hang ” of brushes.
The tool does not switch
on, the indicator of carbon
brushes is lighting.
Carbon brushes are worn. Call the service center.
Increased noise in the gear or
impact mechanism.
Wearout / breakage of the mechanism parts. Call the service center.
When working smoke or smell
of burning insulation goes out
from the vent.
Interturn closure of armature or stator
windings.
Call the service center.
Malfunction of the electrical part of the
instrument.
Tooling is not xed or not
extracted from the box.
Damaged device of the tooling mount. Call the service center.
The use of low-quality tooling. Use high-quality tooling.
STORAGE
During the assigned service life, store Electrical Rotary Hammer in a dry heated room. Recommended storage
temperature is from 0 °C to +40 °C. Store Electrical Rotary Hammer in original packaging.
Before placing the Electrical Rotary Hammer in storage remove the working tool.
TRANSPORTATION
During the transportation direct exposure of precipitation, direct sunlight, heat and shock is not allowed.
Transportation should be carried out only in original packaging at ambient temperature from - 20 °С to + 40 °С.

Содержание

Похожие устройства

Скачать