Panasonic WV-CW504SE [22/32] Lens lens

Step 1

Set "SYNC" to "LL" and press the setting button.

→ The "SYNC" screen appears.

Step 2

Connect the video output signal and external synchronizing input signal of the camera to a 2-input oscilloscope, and move the cursor

to "COARSE".

Step 3

Adjust the oscilloscope to the vertical rate, and extend the vertical synchronizing part of the oscilloscope.

Move the cursor horizontally with use of the right or left button to roughly adjust the vertical phase.

The phase can be adjusted in 16 steps by 22.5 degrees.

1 (1--16) : 0 °/2 (1--16) : 22.5 °/· · ·/16 (1--16) : 337.5

Step 4

Move the cursor to "FINE", and fine adjust vertical phases.

11. lens [LENS]

Select "PANASONIC".

12. Privacy zone setting [PRIVACY ZONE]

When undesired portions in the camera shooting area (on the screen) exist, those portions (privacy zone) are hidden. Up to 8 portions

can be specified for the privacy zone.

ON (1): Grays the zone.

ON (2): Mosaics the zone.

OFF (default): Displays the zone normally.

Follow the procedure below.

Note:

 • Theprivacyzonefunctionisdisabledatinitializingtheunit,i.e.rightafterturningonthepower.

Step 1

Move the cursor to "PRIVACY ZONE", select "ON (1)" or "ON (2)", and press the setting button.

→ The zone setting screen appears.

Step 2

Move the cursor to the number at the right of the title and select the zone number using the right or left button.

**SYSTEM SETUP**

SYNC INT

LENS PANASONIC

PRIVACY ZONE ON(1)

STABILIZER OFF

EL-ZOOM OFF

UPSIDE-DOWN OFF

RET TOP END

"SYSTEM SETUP" screen Zone setting screen

**ZONE NUMBER 1 /8**

POSITION PUSH SW

UPPER LEFT

DEL

RET TOP END