M-Audio HyperControl [5/23] Hypercontrol installation

HyperControl for Logic Pro

User Guide

HyperControl Installation

✓ NOTE: If Logic Pro is running, close the application before beginning the HyperControl installation procedure. The

instructions below will indicate when Logic Pro should be launched.

1. HyperControl technology requires an Axiom Pro “personality” ﬁle to be added to your system. Run the Axiom Pro Logic

HyperControl installer and follow the on-screen instructions.

2. Once the installation is complete, launch Logic Pro.

3. Select “Setup…” from the Logic Pro > Preferences > Control Surfaces menu.

4. Click “New” and select “Install…”

5. Select “M-Audio Axiom Pro 25” (or “M-Audio Axiom Pro” for 49 or 61-key users).

6. Click “Scan.” An Axiom Pro icon will appear on the right side of the screen. Verify that the HyperControl MIDI ports

are

selected for both the “MIDI input” and “MIDI output” drop-down menus on the left side of the screen.

Installation is complete and Logic Pro can now be controlled with Axiom Pro using HyperControl technology. Close the Setup

window and continue to the next section of this User Guide.

Note that HyperControl port names may vary depending on factors your operating system and/or drivers. The table on the next

page describes how Axiom Pro will appear on your system.