HAWK XXT7015IR (1450 об/мин) — инструкция по эксплуатации насосов: безопасное использование и обслуживание [23/31]

Превью страниц Страница 23 / 31

Instructions Manual

Motorpumps

Cod. doc. M.I. EP-18

Issue 0

Page 23 of 31

This Manual remains the property of the Manufacturer; it may not be reproduced or copied, even partially.

When resuming operation of the machine after a long period of inactivity, repeat the checks carried out

prior to the initial start up (section 5.2). Also check the screws and the level of the oil.

5.4 Operation

To safeguard proper pump operation, the pump should preferably be fed (maximum pressure 8 bar), otherwise it should be located

under the water head or at the same level as the tank.

Hawk motorpumps are delivered with their first oil fill and are fitted with a sealed cap to prevent oil spilling during transport. Before

starting to use the pump for the first time, remember to replace the sealed cap with the cap with the dipstick and bleed.

Poor supply can cause serious damage to the pump, such as priming problems, vibration, noise and short

seal life.

The motorpump should not be used at higher pressures or speeds of rotation than those shown on the

product’s specifications plate.