Haier AU182AFMCA [19/25] Malfuncti on
![Haier AB182ACMCA [19/25] Malfuncti on](/views2/1808721/page19/bg13.png)
18
MALFUNCTION?
Care and Cleaning of the unit
Clean with soft and dry cloth.
If it is very dirty, dissolve neutral detergent in the lukewarm water and make the cloth wet with the water.
After wiping, clean off the detergent using clean water.
Post-Season Care
Operate the unit with FAN mode on a fair day for about half a day to dry the inside of the unit well.
Stop operation and turn off the power supply switch. Electric power is consumed even the air conditioner is in stop.
Clean the air filter and set it in the place.
Pre-Season Care
See that there are no obstacles blocking the air inlet and air outlet of both indoor and outoor units.
Make sure that the air filter is not dirty.
Cut in the power supply switch 12 hours before starting run.
Please check the following things about your air conditioner before making a service call.
Unit fails to start
Is the power source switch
cut in?
Is city supply power in nor-
mal?
Isn't the signal receiving sec-
tion exposed to the direct sun-
light or strong illumination?
Isn't the earth leakage
breaker in action?
It is dangerous. Turn off the power supply
switch immediately and contact the sales
dealer.
Cooling or heating is not sufficient
Is the themostat adjust as
required?
Isn't the air filter dirty? Isn't any doors or window
left opened?
Doesn't any obstacle exist
at the air inlet or outlet?
Isn't the swing louver hori-
zontal? (At HEATING mode)
If swing louver is horizontal,
the blow wind does not reach
floor.
The wind does not blow
during heating operation
Isn't it warming up?
Cooling is not sufficient
Isn't sun-shine invading di-
rectly?
Isn't any unexpected heat-
ing load generated?
Isn't the room much crowd-
ed?
Heat generated
by machines
When the air conditioner does not operate properly after you have checked the above
mentioned items or when the following phenomenon is observed, stop the operation of
the air conditioner and contact your sales dealer.
The fuse or breaker often shuts down.
Water drops off during cooling operation.
There is a irregularity in operation or abnormal sound which is audible.
Power
stoppage?
Suitable
temperature
ON
OFF
Power supply
switch is not ON.
Содержание
- Cassette air conditioner 1
- Operation manual 1
- Contents 2
- Cauti ons 3
- Disposal of the old air conditioner 3
- Disposal of the packaging of your new air conditioner 3
- Cauti ons 4
- Air inlet 5
- Air outlet 5
- Compressor inside of unit 5
- I ndoor uni t 5
- Out door uni t 5
- The name of each part and i ts functi on 5
- But t ons and di spl ay of t he remot e cont rol l er 6
- I ntroducti on to spare parts 6
- Oper at i on 6
- Power on off temp 6
- Reset lock 6
- Swi ng 6
- Ti mer 6
- I ntroducti on to spare parts 7
- Oper at i on 7
- Confi rmati on i ndi cator 8
- Load the battery 8
- Loadi ng of the battery 8
- Put on t he cover agai n 8
- Remot e cont rol l er s operat i on 8
- Remote controller operati on 8
- Remove t he bat t ery cover 8
- 1 uni t st art 9
- 2 sel ect oper at i on mode 9
- 4 uni t st op 9
- Fan oper at i on 9
- Gui de to operati on 9
- Hi nt s 9
- 1 uni t st art 10
- 2 sel ect oper at i on mode 10
- 3 sel ect t emp set t i ng 10
- Auto r un cool heat and dry oper at i on 10
- Gui de to operati on 10
- Hi nt s 10
- Recommendat i ons 10
- 4 fan speed sel ect i on 11
- 5 ai r f l ow di rect i on adj ust 11
- 6 uni t st op 11
- Gui de to operati on 11
- Hi nt s 11
- Lo mi d hi auto 11
- Gui de to operati on 12
- Hi nt s 12
- Ti mer on off 12
- Ti mer oper at i on 12
- To cancel ti mer mode 12
- 1 after unit start select your desired operation mode 13
- 2 press timer button to change timer mode 13
- 3 time setting for timer on 13
- 4 time confirming for timer on 13
- 5 time confirming for timer off 13
- 6 time setting for timer off 13
- Gui de to operati on 13
- Timer on off 13
- To cancel timer mode 13
- Adjusting up down air flow direction 14
- Ai r flow di recti on adjustment procedure 14
- Caution 14
- Swing no indication louver stopped 14
- Comf or t abl e sl eep 15
- I n cool i ng dehumi di f yi ng mode 15
- I n heat i ng mode 15
- Power fai l ure resume to be appl i ed for a necessary si tuati on 16
- Remot e cont ro 16
- 4g 0 5m 17
- All the cables shall have got the european allthentication certificate 7 the power supply connects from the indoor side 8 the all pole discon rexion connection method should be applied in the power supply 9 the indoor unit installation height is at least 2 m 17
- Applicable ambient temperature range 17
- Clean the air filter periodically 17
- For comfortable use 17
- For cooling only unit the power cable should be h07rn f 3g 2 m 17
- For heating pump unit or h07rn f 3g 2 m 17
- If the supply cord is damaged it must be replaced by the manufacturer or its service agent or a similar qualified person an extend cord is not recommended the requirement of the power supply cord is h07rn f 3g 2 m 17
- Keep the room temperature to be sui tabl e 17
- Prevent direct sunlight and draft adjust the blow direction clever l y 17
- Suitable for installation in european region 3 if the fuse on pc board is broken please change it with the type of t 3 5a 250v 4 the waste battery shall be disposed properly 5 the wiring method should be in line with the local wiring standard 6 use copper wire only the connecting cable should be h07rn f 2x2m 17
- Use circulator when coldness is felt on your feet during the heat i ng oper at i on 17
- Care and mai ntenance 18
- Care and cleaning of the unit 19
- Cooling or heating is not sufficient 19
- Malfuncti on 19
- Please check the following things about your air conditioner before making a service call 19
- Post season care 19
- Pre season care 19
- Unit fails to start 19
- I s the uni t i nstalled correctly 21
- Warni ng operati on 21
- Cauti ons for i nstallati on 22
- El ect ri c work 22
- Safety precauti ons 22
- Be necessar y 23
- Cauti on 23
- Cauti ons for operati on 23
- Dependi ng on the pl ace of i n 23
- Do not install nearby the place 23
- Do not poke the air inlet or out 23
- Drain pipe should be arranged to 23
- Endure the wei ght of ai r condi 23
- F l ammabl e gas 23
- F or a l ong t i me 23
- Instal l on the pl ace where can 23
- L et wi t h a bar et c 23
- Make sure the system is ground 23
- Provi de a posi ti ve drai ni ng 23
- Securel y to prevent a col l apse 23
- Stallation a circuit breaker may 23
- T i oner 23
- Vail the system should be fixed 23
- Warni ng 23
- When any abnormal condi ti on scorch ing smell or others is found stop the operation immediately and turn off the power swi tch then consul t your deal er 23
- Where may have l eakage of 23
- Where st rong wi nds may pre 23
- You should refrain from exposing 23
- Your body di rectl y to cool wi nd 23
- Safety precauti ons 24
- Hinweise bei der transport oder reparatur 25
- Warning 25
Похожие устройства
- Haier HBU-18HC03 Инструкция по эксплуатации
- Haier HBU-18HC03 Сервис мануал
- Feron CL592 (41643) Инструкция по эксплуатации
- Feron CL592 (41643) Презентация
- Feron CL590 (41635) Инструкция по эксплуатации
- Feron CL590 (41635) Презентация
- Feron CL574 (41652) Инструкция по эксплуатации
- Feron CL574 (41652) Презентация
- Feron CL572 (41647) Инструкция по эксплуатации
- Feron CL572 (41647) Презентация
- Feron CL572 (41648) Инструкция по эксплуатации
- Feron CL572 (41648) Презентация
- Feron CL573 (41650) Инструкция по эксплуатации
- Feron CL573 (41650) Презентация
- Feron CL572 (41649) Инструкция по эксплуатации
- Feron CL572 (41649) Презентация
- Feron CL33 (32426) Инструкция по эксплуатации
- Feron CL33 (32426) Презентация
- Feron CL574 (41653) Инструкция по эксплуатации
- Feron CL574 (41653) Презентация