Bomann GSPE 772.1 [26/31] Extension hose

Positioning the Appliance

How to Drain Excess Water From Hoses

If the sink is 1000 high er from the floor, the excess water in hoses cannot be drained directly

into the sink. It wi ll be necessary to drain excess water from hos es into a bowl or suitable

container that is held outside and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.

Ensure that the water inlet hose is not kinked or squashed.

Syphon Connection

Extension Hose

If you need a drain hose extension , make sure to use a similar drain hose.

It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.

Position the appliance in the desired location. The back should rest against the wall behind it, and the sides,

along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can

be positioned either to the right or the left sides to facilitate p roper installa tion.

The waste conne ction must be at a height of between 40 cm (minimum) and 100 cm (maximum)

from the bottom of the dish. The water drain ho se should be fixed by a hose clip. The free end of

the hose must not be immersed in water.

A hose that attaches to a sink spray can burst if it is installed on the same water line as the dishwasher. If your sink

has one, it is recommended that the hose be disconnected and the hole plugged.

Pull The safety supply hoses completely out from storage compartment located at rear of dishwasher.

Turn water fully on before starting the dishwasher.

Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.

The safety supply hose consists of the double walls. The hose's system guaran tees its intervention by blocking the

flow of water in case of the supply hose b reaking and when the air space between the supply hose itself and the outer

corruga ted hose is full of water.

Turn off the water.

Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the

room, from severe splashing.

Unscrew the safety supply hose from the faucet.

The appliance must be connected to the water mains using new hose-sets.

The old hose-sets should not be reused.

Water pressure must b e between 0,04 MPa and 1 MPa. If the pressure is below the

minimum consult our Service Department for advice.

Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure that it is fastened tightly in place.

If the water pipes are new or have not been used for an extended period of time, let the water run to make sure that the

water is clear and free of impurities. If this precaution is not taken, there is a risk that the water inlet can get blocked

and damage the appliance.