Haier HDV50E1 [10/24] Installation instructions

Превью страниц Страница 10 / 24

INSTALLATION INSTRUCTIONS

Mounting dryer on wall

1 Determine the position of the dryer on the wall and mark the bracket position. A

minimum of 50mm is needed between the top of the dryer and the ceiling for ease

of installation. If mounting above a washing machine, allow sufficient room to open

the lid of the washer.

2 Fix the wall hanging brackets to the wall securely, ie into the stud. If the studs are

too far apart, fit a timber slat to the studs and then mount the brackets to the slat. If

a slat is used install a second slat behind the spacers to ensure the dryer is

horizontal. The distance between the centre of each bracket is 555mm (A).

3 To install the hooks onto the dryer, remove one screw from each side (B), reuse

these screws with two more (each side) from the kit to fasten the hooks in place.

4 Remove plastic plugs from the back of the dryer

and screw the spacers provided in

place (C).

5 With assistance, mount the dryer on the wall brackets.

6 The inverted control panel is supplied in the accessories with your dryer. Fit inverted

control panel over the existing panel.

7 Adjust the display to read correctly on an inverted panel:

■ Press and hold the ‘Key Lock’ and ‘Option’ buttons for three seconds.

■ The dryer will beep to indicate you have made a correct selection, and the display

will change after three seconds.

■ Repeat the same steps to return the panel to the factory setting.

From centre

of top hole

From bottom

of dryer

835mm

555mm