Haier HR24D1VAR — установка и обслуживание климатического оборудования согласно стандартам [15/41]
Превью страниц
Страница 15 /
41
![Haier HR60D1VAR [15/41] Central air conditi oning](/views2/1824559/page15/bgf.png)
.
This product is designed and manufactured to permit installation in accordance with National Codes. It is
prevailing local codes and regulations. The manufacturer assumes no responsibility for equipment
installed in violation of any codes or regulations.
The United States Environmental Protection Agency (EPA) has issued various regulations
may harm the environment and can lead to the imposition of substantial fines. Because these regulations
You should be aware that the use of
unauthorized components, accessories or devices may
adversely
affect the operation of the air
conditioner and may also endanger life and property.
The manufacturer disclaims any responsibility
8.1 OUTDOOR UNIT INSPECTION
8.2 EQUIPMENT PROTECTION FROM ENVIRONMENT
refineries are especially corrosive.
If the unit is to be installed in an area where contaminants are likely to be a problem, special attention
should be given to the equipment location and exposure.
Avoid having lawn sprinkler heads spray directly on the unit cabinet.
In coastal areas, locate the unit on the side of the building away from the waterfront.
Shielding provided by fence or shrubs may give some protection.
Regular maintenance will reduce the buildup of contaminants and help to protect the unit's finish.
! WARNING -
Disconnect all electrical power to the unit before servicing. Disconnect power to both the
8.3 INSTALLATION
regarding the introduction and disposal of refrigerants from this unit. Failure to follow these regulations
the installer's responsibility to install the product in accordance with National Codes and/or
are subject to revision any repair on this unit should be done by a certified technician.
The manufacturer's warranty does not cover any damage failure caused by the air conditioning system.
components, accessories or devices.
for loss or injury due to the use of such unauthorized
Attach the service panel to the outdoor unit after to prevent.
If the service panel is not attached securely, it
could result in a fire or an electric shock due to dust,
water, etc.
This product has been inspected at the factory and released for shipment without known damage. Inspect
oxidation could shorten the unit life. Salt spray or mist in seacoast areas, sulphur or chlorine from lawn
The metal parts of the unit may be subject to rust or corrosion in adverse environmental conditions. This
exterior of carton for evidence of rough handling in shipment. Unpack carefully. If damage is found,
watering systems and various chemical contaminants from industries such as paper mills and petroleum
report immediately to you distributor or the transportation agency.
Structural strength of supporting members
.
the installer's responsibility to insure that the unit is installed in accordance with all local codes.
Clearances and provision for servicing
.
(1) Frequent washing of the cabinet, fan blade and coil with fresh water.
Check the following points before begining any installation:
(2) Regular cleaning and waxing of the cabinet with automobile wax.
(3) An appropriate coil cleaner may be used once per year to remove matter that will not wash off
These units are designed for outdoor installation. They can be mounted on a slab or rooftop. It is
with water.
indoor and outdoor units.
NOTE: There may be more than one electrical disconnect switch. Failure to
shut off power can cause
electrical shock resulting in personal injury or death.
The best protection is frequent cleaning and avoiding exposure to debris that blocks airflow.
15
Central Air Conditioning Model: Heat Pump, HR13-D1
Содержание
137- Hr18d1var hr24d1var
- Service manual
- Models
- Hr60d1var
- Hr48d1var
- Hr42d1var
- Hr36d1var
- Hr30d1var
- Features
- Central air conditioning
- Contents
- Nomenclature for model number
- Description of products features
- Air conditioning
- Service valve
- Central air conditi oning
- Accessories
- Physical and electrical specifications
- Model heat pump hr13 d1
- Central air conditioning
- Model heat pump hr13 d1
- Central air conditioning
- Model heat pump hr13 d1
- Central air conditioning
- Central air conditi oning
- Cautio
- System components and functions
- Safety precautions
- Central air conditi oning
- Service valves
- Refrigerant circuit fig 4 5
- Electrical control devices
- Central air conditi oning
- Central air conditi oning
- Application
- Outdoor unit location proper equipment evacuation outdoor unit refrigerant charge indoor unit air flow indoor unit blower speed supply and return air duct design and sizing system air balancing diffuser and return air grille location and sizing
- Model hr18 60d1var
- Model heat pump hr13 d1
- Conditioning requirements the system must be properly installed proper installation with cerefully distributed air through adequate duct work will provided a comfortable living space
- Central air conditi oning
- And based on engineering data
- After the proper equipment combination has been selected satisfying both sensible and latent
- Unit dimensions
- There are several factors that installers must consider
- The second form of heat is called latent heat this is heat held by the moisture in the air removing this moisture does not affect a thermometer however removing the latent heat in the air greatly increase comfort a properly sized unit removes both forms of heat producing a comfortable conditions an oversized system cycles on and off quickly and does not properly remove humidify producing uncomfortable the indoor and outdoor equipment combination should be matched by the manufacturer
- Table 6 1
- Refrigerant system diagram refer figure 7
- Iston sizes and indoor fan speed
- Installation instructions
- Central air conditi oning
- B6000vd2m22 e hb6000vd2v22 e
- Model heat pump hr13 d1
- Heating
- Figure 7 heat pump refrigerant circuit
- Cooling
- Central air conditi oning
- Equipment protection from environment
- Central air conditi oning
- Warning
- Outdoor unit inspection
- Installation
- Warning
- Unit clearances
- Central air conditi oning
- Refrigerant piping
- Line insulation
- Central air conditi oning
- Interconnecting piping
- Central air conditi oning
- Caution
- Warning
- Evacuation
- Charging the system
- Central air conditi oning
- Electrical wiring
- Central air conditi oning
- System startup
- Operation
- Central air conditi oning
- Service and troubleshooting
- Maintenance instructions
- Central air conditi oning
- Installation and service checklist
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- Warning disconnect all electrical power to the unit before servicing disconnect power to both the indoor and outdoor units note there may be more than one electrical disconnect switch failure to shut off power can cause electrical shock resulting in personal injury or death
- Verify the thermostat and subbase are correct and operate properly
- Verify all the system are in correct position
- Troubleshooting guide
- Symptom possible cause remedy
- Other check points a verify the operating voltage is within the specified range
- Model heat pump hr13 d1
- H verify the refrigerant piping is sized correctly and not pinched
- G verify all ducts and air moving device are sized and operate properly
- E inspect all the other electrical components for proper operation f
- D verify the air conditioning operates properly in cooling
- Central air conditi oning
- B check that all wiring connections are tight c verify that all fuses or circuit breakers are of the proper type and operational
- Model heat pump hr13 d1
- Central air conditi oning
- Heat pump control board
- Electric control b oard and function for central air conditioner
- Central air conditi oning
- When led is used as a status indicator the following codes will be shown 1 in defrost the led will flash 2 seconds on 2 senconds off 1 in the normal operation state and the compressor is running outdoor pcb led will be in the on state 1 in normal state if compressor not running outdoor pcb led wiil be off
- Parameters value of temp sensors
- Outdoor coil temp sensor r25 5k b25 50 3450k with copper terminal
- Model heat pump hr13 d1
- Function selection for sw1 2 sw1 1 on quick defrosting mode used for very cold area please see 5 off default setting normal defrost program please see 5 2 sw1 2 on temperature point from which begin to count for defrost tp 32 off temperature point from which begin to count for defrost tp 35 the setting for sw1 1 sw1 2 when out of factory off off 2 combinatoin of sw1 3 sw1 4 off off current protection value 1 off on current protection value 2 on off current protection value 3 on on current protection value 4 the above current values are set when the equipment is shipped from factory and they will be different values for different models for the relationship between the dip switch setting and the compressor winding circles accross ct please refers to the wiring diagram with the unit
- Function selection
- Central air conditi oning
- Central air conditi oning
- Central air conditi oning
- For 10 sec
- Defrosting operation
- Check and reconnect no record tp0 after compressor on for 8 min
- Central air conditi oning
- Tp tp0 2
- Tp tp0 17
- Tp tp0
- The unit of temp is
- Note the defrost action will be end when defrost has worked for 10 minutes or when the piping temp arrives at or more than 5 0
- Model heat pump hr13 d1
- Is tp pipe temp
- Heat pump mode
- Go to defrost
- For 3 min
- Model heat pump hr13 d1
- Central air conditi oning
- Wiring diagram
- Central air conditi oning
- Sincere forever
Похожие устройства
-
Haier HC60C1VARРуководство по эксплуатации -
Haier HC48C1VARРуководство по эксплуатации -
Haier HC42C1VARРуководство по эксплуатации -
Haier HC36C1VARРуководство по эксплуатации -
Haier HC30C1VARРуководство по эксплуатации -
Haier HC60A1VARСервис мануал -
Haier HC48A1VARСервис мануал -
Haier HC42A1VARСервис мануал -
Haier HC36A1VASСервис мануал -
Haier HC30A1VARСервис мануал -
Haier HC24A1VARСервис мануал -
Haier HC18A1VARСервис мануал
Узнайте, как правильно установить и обслуживать климатическое оборудование в соответствии с национальными стандартами и местными нормами. Обеспечьте безопасность и долговечность устройства.