Haier HW90-B14636N [27/32] Installation

10-Installation

10.7 Fresh water connection

CAUTION!

▶ The drain hose should not be submerged in water and should be securely xed and

leak-free. If the drain hose is placed on the ground or if the pipe is at a height of less

than 80 cm, the washing machine will continuously drain while being lled (self-si-

phoning).

▶ Drain hose is not to be extended. If necessary contact after sales service.

Make sure that the gaskets are inserted.

1. Connect the water inlet hose with the angled

end to the appliance (Fig. 10-10). Tighten the

screw joint by hand.

2. The other end connect to a water tap with a

3/4“ thread (Fig. 10-11).

Note: Aqua-stop system:

Some models are equipped with an aqua-stop inlet hose (B).The aqua-stop system

protects against water damage by automatically cutting the fresh water supply in case

of a leaking hose. This is indicated by a red marker (C). The hose must be replaced.

10.6.3 Drain hose to sink connection

▶ The junction must lie above the siphon.

▶ A spigot connection is usually closed by a pad (A).

That must be removed to prevent any disfunc-

tion (Fig. 10-9).

▶ Secure the drain hose with a clamp.

10-9

10-11

10-10

Following connections are possible:

10.6.1 Drain hose to sink

▶ Hang the drain hose with the U-support over the

edge of a sink with adequate size (Fig. 10-7).

▶

ping.

10.6.2 Drain hose to waste water connection

▶ The internal diameter of the stand pipe with

vent-hole must be minimum 40 mm.

▶ Put the drain hose for approx. 80 mm in the

wastewater pipe.

▶

(Fig. 10-8).

10-7 10-8