Haier HWD-C1000TXVE ME-U [3/21] Before use
![Haier HWD-C1200TXVE-U [3/21] Before use](/views2/1827308/page3/bg3.png)
ELEctRicAL cONNEctiON (UK ONLY)
WAtERMiNAL MARKED N.
thE BROWN WiRE MUSt BE cONNEctED tO thE tERMiNAL
MARKED L.
YOU MUSt MAKE SURE thE LEAD iS FiRMLY SEcURED UNDER
thE cORD cLAMp.
WAtER cONNEctiON
thE pRODUct ShOULD BE cONNEctED tO thE WAtER MAiN
USiNg NEW hOSE SEtS, OLD hOSE SEtS ShOULD NOt BE RE
USED.
thE WAtER pRESSURE MUSt NOt BE LESS thAN 0.03MpA.
cONNEct tO thE WAtER MAiN USiNg A StANDARD 3/4 iNch
thREADED tAp OUtLEt.
iF YOU ARE DiSpOSiNg OF AN OLD AppLiANcE, DiSABLE thE
DOOR LOcK tO AvOiD ENtRApMENt OF chiLDREN WhEN
pLAYiNg.
Do not use a multiple socket extension cord. A separate earthed socket is required which shall be accessible at all times.
If the mains cord becomes damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person
with a lead of the same type and rating to avoid a hazard.
Never remove the plug from the socket by pulling on the cord, always grasp the plug.
The door may get hot during use, do not touch it and keep children away whilst the machine is operating.
Never open the detergent drawer while the machine is running.Hot water and detergent might be ejected.
When installing the product, make sure the mains cord is not trapped or twisted.
WARNINGS:
THIS APPLIANCE IS INTENDED FOR DOMESTIC USE ONLY, COMMERCIAL OR ANY OTHER
USE MAY INVALIDATE THE WARRANTY AND MIGHT BE DANGEROUS.
Never touch or operate the machine with wet hands or when bare footed.
Do not put the machine on a carpet that can block the ventilation slots on the bottom of the unit.
Do not install this machine outdoors or in a damp place or expose it to rain.
Do not install this product near a heat source or in direct sunlight.
Do not place any object on the machine when it is operating.
This appliance must be earthed.
If you are disposing of an old appliance,disable the door lock to avoid entrapment of children when playing and cut off the
mains cord close to the machine.
The appliance must be connected to a 220-240 volts 50 cycle AC supply by means of a three pin socket, suitably earthed and
should be protected by a 13 amp fuse in the plug.
The appliance is supplied with a standard 13 amp 3-pin plug fitted with a 13-amp fuse. Should the fuse require replacement,
it must be replaced with a fuse rated at 13 amps and approved to BS1362.
If the mains plug is unsuitable for the socket outlet in your home or is removed for any other reason,then the cut off plug
should be disposed of safely, do not insert the cut off plug into a mains outlet to prevent the hazard of electric shock. Remove
the fuse before disposal.
There is a danger of electric shock if the cut off plug is inserted into any 13-amp socket outlet.
How to wire a 13 amp plug. (UK Only)
The wires in the mains lead on this appliance are coloured in accordance with the following code:
Green and Yellow - Earth Blue – Neutral Brown – Live
As the colours may not correspond with the markings identifying the terminals in your plug proceed as follows.
The green and yellow wire must be connected to the terminal in the plug which is marked with the
letter E or with the earth symbol or coloured green and yellow.
The blue wire must be connected to the terminal marked N.
The brown wire must be connected to the terminal marked L.
You must make sure the lead is firmly secured under the cord clamp.
WATER CONNECTION
The product should be connected to the water main using new hose sets, old hose sets should not be re used.
The water pressure must not be less than 0.03MPa.
Connect to the water main using a standard 3/4 inch threaded tap outlet.
ImpoRtAnt SAfEtY InfoRmAtIon
03
BEFORE USE
Содержание
- User manual hwd c1000txve me u hwd c1200txve me u hwd c1000txve u hwd c1200txve u 1
- Washer dryer 1
- 09 10 15 16 20 2
- Before use 3
- Electrical connection uk only 3
- If you are disposing of an old appliance disable the door lock to avoid entrapment of children when playing 3
- Important safety information 3
- Water connection the product should be connected to the water main using new hose sets old hose sets should not be re used the water pressure must not be less than 0 3mpa connect to the water main using a standard 3 4 inch threaded tap outlet 3
- Waterminal marked n the brown wire must be connected to the terminal marked l you must make sure the lead is firmly secured under the cord clamp 3
- Before use 4
- Components 4
- Back cover 5
- Back cover screws 3 5
- Before use 5
- Description 5
- Detergent distribution drawer 5
- Display 5
- Door handle 5
- Drain hose 5
- Filter cover 5
- Porthole 5
- Power cord 5
- Power switch 5
- Preparation 5
- Preparing the machine 5
- Program knob 5
- Remove all the packing materials to prevent unsteadiness including the polystyrene base upon opening the package water drops may be seen on the plastic bag and the porthole this is normal phenomenon resulting from water tests in the factory 5
- Sensor dry 5
- This diagram may be slightly different from the layout of the washer dryer you have just purchased due to technical improvements 5
- Transportation bolts 3 5
- Washer door 5
- Water inlet valve 5
- Before use 6
- Safety instructions 6
- Before use 7
- Installation 7
- Before use 8
- Installation 8
- Before use 9
- Control panel 9
- Control panel 10
- Using the appliance using the appliance 10
- Program selection 11
- Using the appliance using the appliance using the appliance 11
- Consumption and technical data 12
- Using the appliance using the appliance 12
- Using the appliance using the appliance using the appliance 13
- Washing drying 13
- Using the appliance using the appliance 14
- Washing drying 14
- After using the appliance 15
- Collect clothes for one full wash load 2 avoid overloading the washer dryer 3 pre wash only heavily soiled clothes 4 reduce the amount of detergent or choose the speed up wash programs for slightly soiled clothes 5 choose a proper washing temperature modern detergents can wash with very good result already in lower temperature than 60 c only user higher temperature than 60 for heavily soiled laundry 6 follow the dosage recommendation on the detergent package to avoid using too much detergent 7 softening agent makes clothes feel softer and easier to iron 8 adding fabric conditioner will also get rid of static condensation to make ironing easier 15
- Drying 15
- For no water heating 15
- If you wish to dry wet laundry please select one of the drying programs by turning the program knob refer to the control panel pages 09 and 10 15
- Press and hold down the speed button until the desired speed is selected or the symbol is selected for no spin see operational functions on the control panel pages 09 and 10 for selecting temperature and spin speed it is advisable to select the recommended value 15
- Press and hold down the temperature button until the desired temperature is selected or the symbol 15
- Press the start pause button the washer dryer will operate according to the pre set programs the washer dryer will stop operation automatically when a washing cycle ends the end sign will appear on the display open the washer door and take out the laundry 15
- Setting spin speed 15
- Setting washing temperature 15
- Tips for saving energy 15
- Turn off the water supply and unplug the power cord open the washer door to prevent formation of moisture and odours let the door open while not used 15
- Using the appliance using the appliance using the appliance 15
- Washing 15
- Washing drying 15
- Using the appliance 16
- Washing drying 16
- Cleaning care 17
- Using the appliance maintenance 17
- Cleaning care 18
- If the machine is to be moved to a distant location replace the transportation locks removed before installation to prevent damage as shown below 18
- If the washer dryer is left idle for a long period pull out the electrical plug and turn off the water supply open the washer dryer door to prevent formation of moisture and odours let the door open while not used 18
- Insert the synthetic stabilisers and the transportation bolts 18
- Long periods of disuse 18
- Maintenance 18
- Moving the machine 18
- Remove the back cover 18
- Remove the blanking plugs 18
- Replace the back cover 18
- Tighten the bolts with a spanner 18
- To prevent blockage to the water supply by ingress of foreign substances clean the water inlet and inlet filter regularly 18
- Water inlet and inlet filter 18
- Display codes 19
- Maintenance 19
- In the unlikely event of difficulties with your appliance please follow the troubleshooting guide below if the problem persists contact the retailer if the machine is still within the guarantee period if the appliance is out of guarantee contact an approved service agent on 0845 025 3025 if an error code is displayed please refer to the error code guide below 20
- Maintenance 20
- Problems possible causes possible solutions 20
- Trouble shooting 20
- Troubleshooting 20
Похожие устройства
- Haier HWD-C1000TXVE ME-U Сервис мануал
- Haier HWD-C1200TXVE ME-U Инструкция по эксплуатации
- Haier HWD-C1200TXVE ME-U Сервис мануал
- Haier HWD-C1200TXVE-F Сервис мануал
- Haier HWD-C1000TXVE-F Сервис мануал
- Haier HWD-C1200TXVE-E Сервис мануал
- Haier HW80-1279 Инструкция по эксплуатации
- Haier HW70-1279 Инструкция по эксплуатации
- Haier HW70-1479 Инструкция по эксплуатации
- LG WP-611NP Инструкция по эксплуатации
- Haier HW80-1479 Инструкция по эксплуатации
- Haier HW70-1479S-F Инструкция по эксплуатации
- Haier HW80-1479-F Инструкция по эксплуатации
- Haier HW80-1479S-F Инструкция по эксплуатации
- Haier HW90-1279-F Инструкция по эксплуатации
- Haier HW60-1479-DF Инструкция по эксплуатации
- Haier HW90-1479-F Инструкция по эксплуатации
- Haier HW70-1279-DF Инструкция по эксплуатации
- Haier HW70-1479-DF Инструкция по эксплуатации
- Haier HW70-1479S-DF Инструкция по эксплуатации