Haier HW60-14829 [17/33] Start wash programme

6-Daily use

1. At programme cycle end END is displayed.

3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.

5. Unplug the power cord.

6. Open the door to prevent formation of moisture and odours. Let it open while not used.

To interrupt a running programme press gently “Start/Pause“. The LED in the button is

ﬂashing. Press it again to resume operation.

To cancel a running programme and all its individual settings

1. Press “Start/Pause” button to interrupt the running programme.

4. Select a new programme and start it.

6.12 After washing

Note: Door lock

▶ For safety reasons the door is locked during the washing cycle. It is only possible to

open the door at the end of the programme or after the programme was cancelled

correctly (see description above).

▶ In case of high water level, high water temperature and during spinning it is not pos-

sible to open the door; Loc

1- is displayed

Note: Standby mode / energy-saving mode

The switched on appliance will go into standby-mode if it will not be activated within 2

This saves energy. To interrupt the standby mode push “Start/Pause“ button.

6.10 Start wash programme

Press “Start/Pause“ button (Fig. 6-10) to start. Appli-

ance operates according to present settings. Changes

are only possible by cancelling the programme.

6.11 Interrupt - cancel wash programme

Start/

Pause

6-10

6.13 Activate or deactivate the buzzer

The acoustic signal can be deselected if necessary:

1. Switch on the appliance.

2. Select the SPIN programme.

3. Press the “Delay “button and “Spin speed” button at the same time for about 3 sec-

onds. “bEEP OFF” will be displayed and the buzzer will be deactivated.

For activating the buzzer press these two buttons at the same time again. “bEEP ON”

will be displayed