![Black & Decker EGBL148K [5/12] Assembly](/img/pdf.png)
Black & Decker EGBL148K [5/12] Assembly
![Black & Decker EGBL148K [5/12] Assembly](/views2/1082973/page5/bg5.png)
5
ENGLISH
(Original instructions)
Vibration
The declared vibration emission values stated in the technical
data and the declaration of conformity have been measured
in accordance with a standard test method provided by
EN 60745 and may be used for comparing one tool with
another. The declared vibration emission value may also be
used in a preliminary assessment of exposure.
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level may
increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons regularly
using power tools in employment, an estimation of vibration
exposure should consider, the actual conditions of use and the
way the tool is used, including taking account of all parts of the
operating cycle such as the times when the tool is switched off
and when it is running idle in addition to the trigger time.
Labels on tool
The following pictograms are shown on the tool:
:
Warning! To reduce the risk of injury, the user
must read the instruction manual.
Additional safety instructions for batteries and
chargers
Batteries
u Never attempt to open for any reason.
u Do not expose the battery to water.
u Do not store in locations where the temperature may
exceed 40 °C.
u Charge only at ambient temperatures between 10 °C and
40 °C.
u Charge only using the charger provided with the tool.
u When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
p
Do not attempt to charge damaged batteries.
Chargers
u Use your Black & Decker charger only to charge the bat-
tery in the tool with which it was supplied. Other batteries
could burst, causing personal injury and damage.
u Never attempt to charge non-rechargeable batteries.
u Have defective cords replaced immediately.
u Do not expose the charger to water.
u Do not open the charger.
u Do not probe the charger.
$
The charger is intended for indoor use only.
+
Read the instruction manual before use.
Electrical safety
#
Your charger is double insulated; therefore no
earth wire is required. Always check that the
mains voltage corresponds to the voltage on the
rating plate. Never attempt to replace the charger
unit with a regular mains plug.
u If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Variable speed switch
2. Forward/reverse slider
3. Mode selector / torque adjustment collar
4. Chuck
5. Speed selector
6. Bit holder
Fig. A
7. Battery
8. Charger
9. Charge Indicator
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (g. B)
u To t the battery (7), line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
u To remove the battery, push the release button (10) while
at the same time pulling the battery out of the receptacle.
Содержание
- English 3
- General power tool safety warnings 3
- Intended use 3
- Safety instructions 3
- Additional power tool safety warnings 4
- English 4
- Residual risks 4
- Additional safety instructions for batteries and chargers 5
- Assembly 5
- English 5
- Features 5
- Fitting and removing the battery fig b 5
- Labels on tool 5
- Vibration 5
- Charger diagnostics 6
- Charging the battery fig a 6
- English 6
- Fitting and removing a drill bit or screwdriver bit 6
- Leaving the battery in the charger 6
- Selecting the direction of rotation fig c 6
- Selecting the operating mode or torque fig d 6
- Batteries 7
- Drilling screwdriving 7
- English 7
- Hints for optimum use 7
- Maintenance 7
- Protecting the environment 7
- Black decker declares that these products described under technical data are in compliance with 2006 42 ec en 60745 1 en 60745 2 6 8
- Ec declaration of conformity 8
- Egbl148 egbl188 8
- English 8
- For more information please contact black decker at the following address or refer to the back of the manual 8
- Kevin hewitt vice president global engineering black decker europe 210 bath road slough berkshire sl1 3yd united kingdom 18 01 2012 8
- Machinery directive 8
- Original instructions 8
- Technical data 8
- The undersigned is responsible for compilation of the technical file and makes this declaration on behalf of black decker 8
- English 9
- Guarantee 9
- Egbl148 egbl188 10
- Do not forget to register your product 11
- English 11
Похожие устройства
- Electrolux ESVMU-28 Инструкция по эксплуатации
- Philips Saeco Exprelia Evo HD8855/09 Инструкция по эксплуатации
- Black & Decker EPC18CA Инструкция по эксплуатации
- Electrolux ESVMD-140 Инструкция по эксплуатации
- Bosch Tassimo TAS5542EE Инструкция по эксплуатации
- Black & Decker EPC148BK Инструкция по эксплуатации
- Electrolux ESVMD-112 Инструкция по эксплуатации
- Bosch Tassimo TAS5543EE Инструкция по эксплуатации
- Black & Decker EPC146 Инструкция по эксплуатации
- Electrolux ESVMD-90 Инструкция по эксплуатации
- Black & Decker EPC14CA Инструкция по эксплуатации
- Philips HP8655/00 Инструкция по эксплуатации
- Electrolux ESVMD-71 Инструкция по эксплуатации
- Black & Decker EPC12CA Инструкция по эксплуатации
- Scarlett SC-207 Инструкция по эксплуатации
- Electrolux ESVMD-56 Инструкция по эксплуатации
- Black & Decker KC36LN Инструкция по эксплуатации
- Electrolux ESVMD-36 Инструкция по эксплуатации
- Black & Decker PP360LN Инструкция по эксплуатации
- Acer S7-191-73514G25ass Инструкция по эксплуатации