Black & Decker BDCS361 [8/152] Assembly

Black & Decker BDCS361 [8/152] Assembly
8
ENGLISH
(Original instructions)
Electrical safety
#
Your charger is double insu-
lated; therefore no earth wire
is required. Always check that
the mains voltage corresponds
to the voltage on the rating
plate. Never attempt to replace
the charger unit with a regular
mains plug.
u If the supply cord is damaged, it must
be replaced by the manufacturer or an
authorised Black & Decker Service Centre
in order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Motion control activator
2. Bit holder
3. Charger connector
4. LED work light
Fig. A
5. Charger
Assembly
Warning! Before assembly, remove the bat-
tery from the tool.
Fitting and removing a screwdriver bit
or socket (g. B)
Warning! Make certain the tool is locked to
prevent switch actuation before installing or
removing accessories.
u To t a screwdriver bit push it into the bit
holder (2) until it locates.
u To remove a screwdriver bit, pull it straight
from the bit holder.
Note! To remove the bit/socket repeat the
above steps.
Use
Warning! Let the tool work at its own pace.
Do not overload.
Charging the battery (g. C)
The battery needs to be charged before rst
use and whenever it fails to produce sufcient
power on jobs that were easily done before.
The battery may become warm while charg-
ing; this is normal and does not indicate a
problem.
u To charge the battery, insert the charger
plug (5) into the charger connector (3).
u Plug in the charger.
u Leave the tool connected to the charger
for 16 hours.

Содержание

Похожие устройства

Скачать
Случайные обсуждения