Beon BN-8704 [12/16] Instruction manual

12 INSTRUCTION MANUAL

 To obtain a powerful steam boost, press the steam boost button (9) twice to three times for a

short period of time. When steaming, a small amount of hot water can be discharged from the

outlet of the sole of the iron (1). If you press the steam button (9) too often, the temperature of

the sole of the iron may fall below the set temperature. Stop pressing the steam button (9) and

let the iron heat up.

 At the end of Ironing, allow the sole of the iron to cool to room temperature and disconnect

the device from the mains.

 Do not press this button more than 3 times at once.

Auto shut off

The light comes on to indicate that shut off has tripped. As soon as you move the iron, the device

turns off and the iron starts working again.

Anti-drip system

The iron is equipped with a special protective system that prevents water leakage when ironing at

low temperature. Now you can iron the most delicate fabrics without fear of spoiling. At a

temperature below the required to generate steam, the system will automatically start to work and

no drop of water will leave more stains on your things.

Anti-calk system

 This model of iron is equipped with a descaling filter. It softens hard water and prevents the

formation of sludge and scale.

 Do not use water softening chemicals and ant scale agents. They can cause damage to the

instrument.

CLEANING AND MAINTENANCE

 Before cleaning, disconnect the appliance from the mains, empty the tank of remaining water

and allow to cool completely. Do not use solvents or abrasives when cleaning.

 Wipe the surface of the iron with a soft, damp cloth.

 Try not to scratch the soleplate of the iron. Avoid sharp contact with ENG metal objects.

 Cleaning of the soleplate of the iron should be done after each use.

Self-clean system

Fill the water tank of the appliance (3) by half, set the temperature control to the maximum

position, and turn the iron on to the network. Wait for the iron to heat up, then unplug it and hold it

horizontally above the sink, press the self-cleaning button (6).

Water with scale and dirt particles will come out of the holes in the sole.

Allow the iron to cool down after this procedure.

For final cleaning of the steam holes on the work surface, iron a damp cloth.

At the end of the cleaning process, set the temperature regulator (2) to "0".